Modelling of liquid flat-plate solar collector operation in transient states

The article presents a one-dimensional mathematical model for simulating the transient processes which occur in liquid flat-plate solar collectors. The proposed method considers a collector model with distributed parameters. In the model, the boundary conditions can be time dependent. The proposed model is based on solving equations which describe the energy conservation for the glass cover, air gap between cover and absorber, absorber, working fluid, and insulation. The differential equations derived were solved using the implicit finite-difference method in an iterative scheme. All thermo-physical properties of the fluid, absorber and air gap are computed in real time. The time-spatial distributions of heat transfer coefficients are also computed in the on-line mode. In order to experimentally verify the proposed method, a test bench was built and measurements were carried out. Comparing the measurement results of the transient fluid temperature at the collector outlet with computational results, satisfactory convergence is found. The proposed method is appropriate for the verification of the effectiveness of various absorbers and their surface coatings, without the need to carry out research on existing collectors. It allows the influence of fluid mass flowrate on the collector performance to be analysed and collector time constant to be determined. The presented model is suitable for collectors working in a parallel or in a serpentine tube arrangement with single or double covers.

[1]  Georgios Martinopoulos,et al.  CFD modeling of a polymer solar collector , 2010 .

[2]  Brian Norton,et al.  Geographic Variation of Solar Water Heater Performance in Europe , 2006 .

[3]  M. Augustus Leon,et al.  Mathematical modeling and thermal performance analysis of unglazed transpired solar collectors , 2007 .

[4]  Masud Behnia,et al.  Water-in-Glass Evacuated Tube Solar Water Heaters , 2004 .

[5]  Panna Lal Singh,et al.  Heat loss study of trapezoidal cavity absorbers for linear solar concentrating collector , 2010 .

[6]  N. Molero Villar,et al.  Numerical 3-D heat flux simulations on flat plate solar collectors , 2009 .

[7]  W. Kamminga,et al.  The approximate temperatures within a flat-plate solar collector under transient conditions , 1985 .

[8]  X. A. Wang,et al.  Analysis and performance of flat-plate solar collector arrays , 1990 .

[9]  S. Janjai,et al.  Modelling the performance of a large area plastic solar collector , 2000 .

[10]  P. A. Sheppard,et al.  Long-wave radiation from clear skies , 1964 .

[11]  Simon Furbo,et al.  Flow distribution in a solar collector panel with horizontally inclined absorber strips , 2007 .

[12]  T. Unny,et al.  Free convective heat transfer across inclined air layers , 1976 .

[13]  Gunnar Tamm,et al.  New and emerging developments in solar energy , 2004 .

[14]  W. Spirkl,et al.  Dynamic solar collector performance testing , 1993 .

[15]  F. M. Hughes,et al.  Resonance characteristics of distributed solar collector fields , 1993 .

[16]  Jürgen Schnieders,et al.  Comparison of the energy yield predictions of stationary and dynamic solar collector models and the models' accuracy in the description of a vacuum tube collector , 1997 .

[17]  A. Oliva,et al.  Numerical simulation of solar collectors: The effect of nonuniform and nonsteady state of the boundary conditions , 1991 .

[18]  Timothy Nicholas Anderson,et al.  The effect of colour on the thermal performance of building integrated solar collectors , 2010 .

[19]  K. Vajen,et al.  NUMERICAL SOLUTION AND VALIDATION OF A DYNAMIC MODEL OF SOLAR COLLECTORS WORKING WITH VARYING FLUID FLOW RATE , 1999 .

[20]  Andreas Richter,et al.  Flow distribution in solar collectors with laminar flow conditions , 2002 .

[21]  M. Mahmoodi,et al.  Rate of heat transfer in polypropylene tubes in solar water heaters , 2003 .

[22]  Soteris A. Kalogirou,et al.  Prediction of flat-plate collector performance parameters using artificial neural networks , 2006 .

[23]  J. Cadafalch,et al.  A detailed numerical model for flat-plate solar thermal devices , 2009 .