Resistive CO gas sensors based on In2O3 and InSnOx nanopowders synthesized via starch-aided sol-gel process for automotive applications

Abstract Pure and Sn-doped In 2 O 3 nanopowders have been synthesized by a starch-aided sol–gel process. A detailed characterization by means of TEM and HRTEM, TG–MS, XRD and 119 Sn solid-state NMR analysis has been carried out. It has shown that the grains of the samples as-synthesized and dried at 120 °C are in the nanometer range. Moreover, on the Sn-doped In 2 O 3 sample, the homogeneous distribution of the dopant with no segregation phase effects has been demonstrated. The thermal treatment at 550 °C induced an increase of grain size up to about 30 nm and of crystallinity. The behaviour of the resistive gas sensors based on the synthesized nanopowders in the monitoring of carbon monoxide for automotive applications has been evaluated. Electrical and sensing tests have been performed on the sensor devices in a thick film configuration depositing pure and Sn-doped In 2 O 3 nanopowders by screen-printing over a ceramic substrate. The results have been discussed in relation to the chemical and microstructural properties of the synthesized nanopowders. The good sensing behaviour of these samples has been associated with their special features such as very small grains and high oxygen vacancies due to the peculiar reductive character of starch pyrolysis.

[1]  A. Cornet,et al.  The influence of additives on gas sensing and structural properties of In2O3-based ceramics , 2007 .

[2]  U. Diebold,et al.  Surface oxygen chemistry of a gas-sensing material: SnO2(101) , 2004 .

[3]  Yuzo Shigesato,et al.  Electrical and structural properties of low resistivity tin‐doped indium oxide films , 1992 .

[4]  G. Neri,et al.  Non-aqueous routes to crystalline metal oxide nanoparticles: Formation mechanisms and applications , 2005 .

[5]  Jun Jin,et al.  The effect of oxygen vacancies concentration to the gas-sensing properties of tin dioxide-doped Sm , 2000 .

[6]  E. Callone,et al.  Nanopowders of metallic oxides prepared by the hydrolytic route with starch stabilization and biological abetment. , 2006, Journal of Nanoscience and Nanotechnology.

[7]  S. Capone,et al.  Nanostructured In2O3-SnO2 sol-gel thin film as material for NO2 detection , 2006 .

[8]  J. Yao,et al.  Preparation of indium tin oxide (ITO) with a single-phase structure , 2003 .

[9]  H. Enoki,et al.  The intermediate compound in the In2O3-SnO2 system , 1991 .

[10]  S. J. Gregg,et al.  Adsorption Surface Area and Porosity , 1967 .

[11]  G. Neri,et al.  A highly sensitive oxygen sensor operating at room temperature based on platinum-doped In2O3 nanocrystals. , 2005, Chemical communications.

[12]  Giovanni Neri,et al.  Nonaqueous synthesis of nanocrystalline semiconducting metal oxides for gas sensing. , 2004, Angewandte Chemie.

[13]  G. Korotcenkov.  Gas response control through structural and chemical modification of metal oxide films: state of the art and approaches , 2005 .

[14]  D. Raoufi,et al.  Surface characterization and microstructure of ITO thin films at different annealing temperatures , 2007 .

[15]  S. Ramanan,et al.  Dip coated ITO thin-films through sol–gel process using metal salts , 2001 .

[16]  E. Callone,et al.  Size stabilization of nanoparticles by polysaccharides: Effectiveness in the wet and curing steps , 2007 .

[17]  Sudipta Seal,et al.  Nanocrystalline indium oxide-doped tin oxide thin film as low temperature hydrogen sensor , 2004 .

[18]  Hidemoto Nakagawa,et al.  An automated car ventilation system , 2000 .

[19]  Electrical, Optical, and Structural Properties of Tin-Doped In2O3–M2O3 Solid Solutions (M=Y, Sc) , 2000 .

[20]  P. Kirszensztejn,et al.  31P and119Sn high resolution solid state CP/MAS NMR study of Al2O3-SnO2 systems , 1994 .

[21]  V. Sudarsan,et al.  Non-random distribution of cations in Sn1 − xTixO2(0.0 ≤ x ≤ 1.0): a 119Sn MAS NMR study , 2001 .

[23]  S. Ayres,et al.  Health effects of exposure to high concentrations of automotive emissions. Studies in bridge and tunnel workers in New York City. , 1973, Archives of environmental health.

[24]  Kosmas Galatsis,et al.  INVESTIGATION OF GAS SENSORS FOR VEHICLE CABIN AIR QUALITY MONITORING , 2010 .

[25]  R. D. Shannon.  Revised effective ionic radii and systematic studies of interatomic distances in halides and chalcogenides , 1976 .

[26]  Dan Li,et al.  Shape and aggregation control of nanoparticles: not shaken, not stirred. , 2006, Journal of the American Chemical Society.

[27]  G. Frank,et al.  Electrical properties and defect model of tin-doped indium oxide layers , 1982 .

[28]  Giovanni Neri,et al.  Effect of the chemical composition on the sensing properties of In2O3–SnO2 nanoparticles synthesized by a non-aqueous method , 2008 .

[29]  Kenzi Suzuki,et al.  Synthesis of new Sn incorporated layered double hydroxides and their evolution to mixed oxides , 1999 .

[30]  X. W. Wang,et al.  RF aerosol plasma fabrication of indium tin oxide and tin oxide thin films , 1996 .

[31]  S. Iannotta,et al.  Innovative aspects in thin film technologies for nanostructured materials in gas sensor devices , 2003 .

[32]  F. Kruis,et al.  Size-dependent gas sensing properties of indium oxide nanoparticle layers. , 2007, Journal of nanoscience and nanotechnology.

[33]  N. Yamazoe,et al.  Oxide Semiconductor Gas Sensors , 2003 .

[34]  P. Siciliano,et al.  Nanocrystalline Metal Oxides from the Injection of Metal Oxide Sols in Coordinating Solutions: Synthesis, Characterization, Thermal Stabilization, Device Processing, and Gas‐Sensing Properties , 2006 .

[35]  Alexander V. Neimark,et al.  Surface Area and Porosity , 2008 .

[36]  E. Callone,et al.  Nanometric oxides from molecular precursors in the presence of starch: Coatings of glass with these oxides in silica sols , 2006 .

[37]  Clément Sanchez,et al.  Sol-gel chemistry of transition metal oxides , 1988 .

[38]  P. Siciliano,et al.  Oxide nanocrystals from a low-temperature, self-limiting sol–gel transition in a coordinating environment: Nanocrystal synthesis, processing of gas-sensing devices and application to organic compounds , 2007 .

[39]  A. Rabenau,et al.  X-ray and optical measurements in the In2O3SnO2 system , 1979 .

[40]  G. Sberveglieri,et al.  In2O3 nanowires for gas sensors : morphology and sensing characterisation , 2007 .

[41]  M. Uhrmacher,et al.  Hyperfine interactions and site occupancy in Sn‐doped In2O3 (ITO) , 2005 .

[42]  L. Lutterotti.  Maud: a Rietveld analysis program designed for the internet and experiment integration , 2000 .

[43]  Z. Jarzȩbski.  Preparation and Physical Properties of Transparent Conducting Oxide Films , 1982, May 16.

[44]  F. Ménil,et al.  Influence of the densification parameters on screen-printed component properties , 2005 .