Design and simulation of closed loop controller for SEPIC converter to improve power factor

One of the solid state switch mode rectification converters is SEPIC converter. This paper presents the design, simulation and development of single phase AC-DC SEPIC converter with 1.5W output power. The non-isolated SEPIC converter is performed in this paper. The control techniques such as voltage follower control, average current control with voltage follower, borderline control technique are implemented to improve the overall power factor and to reduce Total Harmonic Distortion.

[1]  Bhim Singh,et al.  Analysis, Design and Development of a Single Switch Flyback Buck-Boost AC-DC Converter for Low Power Battery Charging Applications , 2007 .

[2]  N Femia,et al.  Stability Issues in Peak-Current-Controlled SEPIC , 2011, IEEE Transactions on Power Electronics.

[3]  S. T. Jaya Christa,et al.  Single phase positive output super-lift luo converter fed high power LED lamp with unity power factor and reduced source current harmonics , 2016 .

[4]  Esam H. Ismail,et al.  Bridgeless SEPIC Rectifier With Unity Power Factor and Reduced Conduction Losses , 2009, IEEE Transactions on Industrial Electronics.

[5]  Giorgio Spiazzi,et al.  High-quality rectifier based on coupled-inductor Sepic topology , 1994, Proceedings of 1994 Power Electronics Specialist Conference - PESC'94.

[6]  S.T. Jaya Christa,et al.  Analysis and Design of Single Phase AC-DC Modified SEPIC Converter , 2014 .

[7]  A. Aswini,et al.  Power Quality Improvement in Single Phase AC-DC Three Level Boost Converter Using PI and SMC , 2014 .

[8]  J. Gnanavadivel,et al.  Comparative Study of PI, Fuzzy and Fuzzy tuned PI Controllers for Single-Phase AC-DC Three-Level Converter , 2017 .

[9]  Fred C. Lee,et al.  Small-signal modeling of average current-mode control , 1992, [Proceedings] APEC '92 Seventh Annual Applied Power Electronics Conference and Exposition.

[10]  J. Gnanavadivel,et al.  Implementation of FPGA based three-level converter for LED drive applications , 2016 .

[11]  Javier Uceda,et al.  The discontinuous conduction mode Sepic and Cuk power factor preregulators: analysis and design , 1997, IEEE Trans. Ind. Electron..