Remote Control System at 110/20 kV Substation for Wind Park “Bogdanci”

Remote control systems have become an integral part of the modern substations worldwide. Known as SCADA systems they have been implemented in wide range of the new substations from 110 kV up to 400 kV level. Paper presents the SCADA solution in the new 110/20 kV susbstation Bogdanci, constructed for the connection of the wind park Bogdanci to the power gird. The system was significantly enhanced by implementing IEC 61850 protocol thus establishing a secure and fast communication with intelligent electronic devices (IEDs) in signal and in the command direction as well. System is based on Sicam Pas Siemens solution with redundant optical ring, two Sicam Pas stations and redundant visualization computers. The wind park was put into operation in 2015 and with its installed power of 36.8 MW has significantly contributed to the country’ economy and increased the portion of electricity produced from renewable energy sources. The 110/20 kV substation with its remote control system integrated into SCADA system of national dispatching center (NDC) has enhanced the network security and reliability.

[1]  Mohammad Ataei,et al.  Substation automation system using IEC 61850 , 2011, 2011 5th International Power Engineering and Optimization Conference.

[2]  J-C·图尼耶,et al.  Substation Automation system, and , 2009 .

[3]  W. J. Ackerman.  Substation automation and the EMS , 1999, 1999 IEEE Transmission and Distribution Conference (Cat. No. 99CH36333).

[4]  Alessandro Leonardi,et al.  Towards the Smart Grid: Substation Automation Architecture and Technologies , 2014 .

[5]  Mark Nakao,et al.  Integrating modern substation automation systems with enterprise-level management , 2015, 2015 68th Annual Conference for Protective Relay Engineers.

[6]  Miro Antonijević,et al.  Augmented Reality Applications for Substation Management by Utilizing Standards-Compliant SCADA Communication , 2018 .

[7]  Wei-Jen Lee,et al.  Electrical substation automation system modernization through the adoption of IEC61850 , 2015, 2015 IEEE/IAS 51st Industrial & Commercial Power Systems Technical Conference (I&CPS).

[8]  Musse Mohamud Ahmed.  New Supervisory Control and Data Acquisition (SCADA) based fault isolation system for low voltage distribution systems , 2010, International Conference on Computer and Communication Engineering (ICCCE'10).

[9]  R. Kirkman.  Development in Substation Automation Systems , 2007, 2007 International Conference on Intelligent Systems Applications to Power Systems.