Incorporation of beams into bossed diaphragm for a high sensitivity and overload micro pressure sensor.

The paper presents a piezoresistive absolute micro pressure sensor, which is of great benefits for altitude location. In this investigation, the design, fabrication, and test of the sensor are involved. By analyzing the stress distribution of sensitive elements using finite element method, a novel structure through the introduction of sensitive beams into traditional bossed diaphragm is built up. The proposed configuration presents its advantages in terms of high sensitivity and high overload resistance compared with the conventional bossed diaphragm and flat diaphragm structures. Curve fittings of surface stress and deflection based on ANSYS simulation results are performed to establish the equations about the sensor. Nonlinear optimization by MATLAB is carried out to determine the structure dimensions. The output signals in both static and dynamic environments are evaluated. Silicon bulk micromachining technology is utilized to fabricate the sensor prototype, and the fabrication process is discussed. Experimental results demonstrate the sensor features a high sensitivity of 11.098 μV/V/Pa in the operating range of 500 Pa at room temperature, and a high overload resistance of 200 times overpressure to promise its survival under atmosphere. Due to the excellent performance above, the sensor can be applied in measuring the absolute micro pressure lower than 500 Pa.

[1]  Ding Jianning,et al.  Fabrication and temperature coefficient compensation technology of low cost high temperature pressure sensor , 2005 .

[2]  Akio Yasukawa,et al.  A special silicon diaphragm pressure sensor with high output and high accuracy , 1981 .

[3]  Ralph H. Johnson,et al.  A high-sensitivity ribbed and bossed pressure transducer , 1992 .

[4]  Chie Gau,et al.  Micro pressure sensor fabrication without problem of stiction for a wider range of measurement , 2004, Proceedings of IEEE Sensors, 2004..

[5]  Zhuangde Jiang,et al.  Surface stress-induced deflection of a microcantilever with various widths and overall microcantilever sensitivity enhancement via geometry modification , 2011 .

[6]  Ernst Obermeier,et al.  AeroMEMS sensor array for high-resolution wall pressure measurements , 2006 .

[7]  Wang Yan,et al.  Micromachined beam-diaphragm structure improves performances of pressure transducer , 1990 .

[8]  M. Madou.  Fundamentals of microfabrication , 1997 .

[9]  Ha-Duong Ngo,et al.  Design and simulation of ultra high sensitive piezoresistive MEMS sensor with structured membrane for low pressure applications , 2010, 2010 12th Electronics Packaging Technology Conference.

[10]  Liwei Lin,et al.  A simulation program for the sensitivity and linearity of piezoresistive pressure sensors , 1999 .

[11]  P. W. Chapman,et al.  Silicon Diffused-Element Piezoresistive Diaphragms , 1962 .

[12]  Zhuangde Jiang,et al.  The design and analysis of beam-membrane structure sensors for micro-pressure measurement. , 2012, The Review of scientific instruments.

[13]  James H. Smith,et al.  Micromachined pressure sensors: review and recent developments , 1997 .

[14]  Thomas W. Kenny,et al.  Packaging a piezoresistive pressure sensor to measure low absolute pressures over a wide sub-zero temperature range , 2000 .

[15]  Beth L. Pruitt,et al.  Review: Semiconductor Piezoresistance for Microsystems , 2009, Proceedings of the IEEE.

[16]  K. Wise,et al.  Pressure sensitivity in anisotropically etched thin-diaphragm pressure sensors , 1979, IEEE Transactions on Electron Devices.

[17]  O. N. Tufte,et al.  Piezoresistive Properties of Silicon Diffused Layers , 1963 .