Gate Capacitance Characterization of Silicon Carbide and Silicon Power mosfets Revisited

Capacitance–voltage (C–V) gate characteristics of power metal-oxide-semiconductor field-effect transistors (<sc>mosfet</sc>s) play an important role in the dynamic device performance. C–V characterization of the <sc>mosfet</sc> gate structure is a necessary step for evaluating the <sc>mosfet</sc> switching behavior and calibrating lumped equivalent capacitances of <sc>mosfet</sc> compact models. This article presents a comprehensive analysis on gate C–V measurements of silicon (Si) and silicon carbide (SiC) power <sc>mosfet</sc>s leading to clear measurement guidelines. The requirements on the measurement setup, the selection of equivalent models used for the <sc>mosfet</sc> capacitance extraction, and the measurement frequency range are defined and supported by an accurate C–V characterization of several Si- and SiC power <sc>mosfet</sc>s. The results show that the gate-source and gate-drain capacitances should be extracted at a frequency of some 10 kHz rather than at 1 MHz, as typically adopted in datasheets, to avoid parasitic effects introduced by the measurement setup and package. Furthermore, analytical expressions for <inline-formula><tex-math notation="LaTeX">$C_\text{dg}$</tex-math></inline-formula> and <inline-formula><tex-math notation="LaTeX">$C_\text{sg}$</tex-math></inline-formula> were derived based on a lumped equivalent circuit, which explain the influence of the measurement setup and the package parasitics on the C–V measurements. Nonideal measurement conditions are identified and correlated to the differences in C–V extraction with either parallel or series-equivalent model. A new method is proposed to estimate the ratio of the <sc>mosfet</sc>’s <sc>on</sc>-state resistance components <inline-formula><tex-math notation="LaTeX">$R_\text{ch}$</tex-math></inline-formula> and <inline-formula><tex-math notation="LaTeX">$R_\text{drift}$</tex-math></inline-formula> based on the presented C–V measurement guidelines, which are applicable to all three- and four-terminal power <sc>mosfet</sc>s.