Effect of thermal cycling on commercial thermoelectric modules

The large temperature gradients experienced by thermoelectric modules induce significant thermal stresses which eventually lead to device failure. The impact of thermal cycling on a commercial thermoelectric module is investigated through characterization of the electrical properties. In this work, we measure the evolution of the thermoelectric and electrical properties with thermal cycling. One side of the thermoelectric module is cycled between 30°C and 160°C every 3 minutes while the other side is held at ~20°C. The thermoelectric figure of merit, ZTET̅, and electrical resistivity are measured after every 1000 cycles. The measured ZTET̅ value is compared using both a modified Harman method and an electrical measurement technique analyzed with an electrical circuit model. In addition, the change in output power and resistivity with cycling are reported. This study provides insight into characterization methods for thermoelectric modules and quantifies reliability characteristics of thermoelectric modules.

[1]  T. Hogan,et al.  Characterization of thermoelectric elements and devices by impedance spectroscopy. , 2007, The Review of scientific instruments.

[2]  R. Coben,et al.  Infrared Imaging and Neurofeedback: Initial Reliability and Validity , 2008 .

[3]  D. Rowe CRC Handbook of Thermoelectrics , 1995 .

[4]  K. Paraskevopoulos,et al.  Efficiency Study of a Commercial Thermoelectric Power Generator (TEG) Under Thermal Cycling , 2010 .

[5]  Gao Min,et al.  Evaluation of thermoelectric modules for power generation , 1998 .

[6]  M. Asheghi,et al.  A reliability study with infrared imaging of thermoelectric modules under thermal cycling , 2012, 13th InterSociety Conference on Thermal and Thermomechanical Phenomena in Electronic Systems.

[7]  Y. Hori,et al.  Analysis on thermo-mechanical stress of thermoelectric module , 1999, Eighteenth International Conference on Thermoelectrics. Proceedings, ICT'99 (Cat. No.99TH8407).

[8]  A reliability study of a miniature thermoelectric generator , 1994 .

[9]  Mohamed S. El-Genk,et al.  Tests results and performance comparisons of coated and un-coated skutterudite based segmented unicouples , 2006 .

[10]  G. Subbarayan,et al.  Powercycling Reliability, Failure Analysis and Acceleration Factors of Pb-Free Solder Joints , 2005, Proceedings Electronic Components and Technology, 2005. ECTC '05..

[11]  T. Harman,et al.  Measurement of Thermal Conductivity by Utilization of the Peltier Effect , 1959 .

[12]  R. Venkatasubramanian,et al.  Thin-film thermoelectric devices with high room-temperature figures of merit , 2001, Nature.