The development and assessment of an aspiration efficiency reducing system of air pollution control for particulate matter in building ventilation systems

Abstract An air pollution control device, designed to restrict the amount of particulate matter passing through it, was developed on the principle of aspiration efficiency. The performance of this new form of air pollution control was subsequently assessed in terms of its remediation efficiency for PM2.5 at the ventilation inlet of a medium sized city centre office building. A physical prototype and 3D computational fluid dynamics model were both developed to assess the performance of the device. The results of the investigation indicated that the device was capable of restricting the passage of 5–87% of PM2.5 into the ventilation inlet of the commercial building depending on ambient conditions (50% on average). The performance of the device was found to vary significantly according to the magnitude of ambient wind speed and the ventilation flow rate through the building. This new device demonstrates the potential of aspiration efficiency as a mechanism of air pollution control offering two notable advantages, (i) no consumable material requirements and (ii) reduced energy consumption, over existing technology. The technology has the potential to reduce the operating costs of ventilations systems, reducing CO2 emissions in buildings as a consequence.

[1]  K. Willeke,et al.  A general equation for aerosol aspiration by thin-walled sampling probes in calm and moving air , 1993 .

[2]  L. Gill,et al.  The Control of Environmental Tobacco Smoke: A Policy Review , 2009, International journal of environmental research and public health.

[3]  K. Willeke,et al.  MEASUREMENT OF THE SAMPLING EFFICIENCY OF PERSONAL INHALABLE AEROSOL SAMPLERS USING A SIMPLIFIED PROTOCOL , 2000 .

[4]  A. McNabola.  New Directions: Passive control of personal air pollution exposure from traffic emissions in urban street canyons , 2010 .

[5]  Zhi Ning,et al.  Experimental and numerical study of the dispersion of motor vehicle pollutants under idle condition , 2005 .

[6]  Servet Soyguder,et al.  Intelligent system based on wavelet decomposition and neural network for predicting of fan speed for , 2011 .

[7]  H Kromhout,et al.  A collaborative European study of personal inhalable aerosol sampler performance. , 1997, The Annals of occupational hygiene.

[8]  David Styles,et al.  A quantitative integrated assessment of pollution prevention achieved by integrated pollution prevention control licensing. , 2009, Environment international.

[9]  Sarah J. Dunnett.  A numerical study of the aspiration efficiency of a thin-walled sampler facing the wind for high velocity ratios , 2005 .

[10]  Andrew D. Maynard,et al.  The sampling efficiency of personal inhalable aerosol samplers in low air movement environments , 1999 .

[11]  A. McNabola,et al.  Modelling the impacts of a carbon emission-differentiated vehicle tax system on CO2 emissions intensity from new vehicle purchases in Ireland , 2009 .

[12]  Claude-Alain Roulet,et al.  Energy in air-handling units—results of the AIRLESS European Project , 2004 .

[13]  Ángeles Montoro-Sánchez,et al.  Some lessons from incentive theory: Promoting quality in bus transport , 2011 .

[14]  Yoshiyuki Shimoda,et al.  Energy saving potential of cooperative management between DHC plant and building HVAC system , 2012 .

[15]  M. Krämer,et al.  Sampling characteristics of inlets operated at low U/U0 ratios: new insights from computational fluid dynamics (CFX) modeling , 2004 .

[16]  Andrew D. Maynard,et al.  Aerosol inhalability in low air movement environments , 1999 .

[17]  Z. Bai,et al.  Regulatory standards related to building energy conservation and indoor-air-quality during rapid urbanization in China , 2004 .

[18]  Sarah J. Dunnett,et al.  A MATHEMATICAL STUDY OF AEROSOL SAMPLING BY AN IDEALISED BLUNT SAMPLER ORIENTED AT AN ANGLE TO THE WIND: THE ROLE OF GRAVITY , 2000 .

[19]  Chris Manzie,et al.  Fuel economy improvements for urban driving : Hybrid vs. intelligent vehicles , 2007 .

[20]  H. R. Anderson,et al.  The impact of the congestion charging scheme on ambient air pollution concentrations in London , 2009 .

[21]  M Williams,et al.  Air pollution and policy--1952-2002. , 2004, The Science of the total environment.

[22]  R. Colvile,et al.  Design and validation of a high-flow personal sampler for PM2.5 , 2001, Journal of Exposure Analysis and Environmental Epidemiology.

[23]  Aonghus McNabola,et al.  A numerical analysis of the aspiration efficiency of a personal sampler , 2010 .

[24]  S. Dunnett.  A mathematical study of particle motion during calm air sampling , 2000 .

[25]  Brian G. Miller,et al.  Aerosol inhalability at higher windspeeds , 1990 .

[26]  L Armbruster,et al.  Investigations into defining inhalable dust. , 1982, The Annals of occupational hygiene.

[27]  D. Dockery,et al.  Effect of air-pollution control on death rates in Dublin, Ireland: an intervention study , 2002, The Lancet.

[28]  X. Wen,et al.  A numerical study of the sampling efficiency of a tube sampler operating in calm air facing both vertically upwards and downwards , 2002 .

[29]  Derek B. Ingham,et al.  ASPIRATION EFFICIENCY OF A THIN-WALLED CYLINDRICAL AEROSOL SAMPLER AT YAW ORIENTATIONS WITH RESPECT TO THE WIND , 2000 .

[30]  James H. Vincent,et al.  Porous plastic foam filtration media: Penetration characteristics and applications in particle size-selective sampling , 1993 .

[31]  Parham A. Mirzaei,et al.  A novel approach to enhance outdoor air quality: Pedestrian ventilation system , 2010 .

[32]  L. Kenny,et al.  Sampling characteristics of modified personal inhalable sampler inlets. , 1997 .

[33]  Otto Hänninen,et al.  Fine Particle (PM25) Measurement Methodology, Quality Assurance Procedures, and Pilot Results of the EXPOLIS Study. , 1999, Journal of the Air & Waste Management Association.