Certain commercial entities, equipment, or materials may be identified in this document in order to describe an experimental procedure or concept adequately. Such identification is not intended to imply recommendation or endorsement by the National Institute of Standards and Technology, nor is it intended to imply that the entities, materials, or equipment are necessarily the best available for the purpose. The policy of the National Institute of Standards and Technology is to use the International System of Units (metric units) in all of its publications. However, in North America in the heating, ventilation and airconditioning industry, certain non-SI units are so widely used instead of SI units that it is more practical and less confusing to include some measurement values in customary units only. Software Disclaimer This software was developed at the National Institute of Standards and Technology by employees of the Federal Government in the course of their official duties. Pursuant to title 17 Section 105 of the United States Code this software is not subject to copyright protection and is in the public domain. These programs are experimental systems. NIST assumes no responsibility whatsoever for their use by other parties, and makes no guarantees, expressed or implied, about its quality, reliability, or any other characteristic. We would appreciate acknowledgement if the software is used. This software can be redistributed and/or modified freely provided that any derivative works bear some notice that they are derived from it, and any modified versions bear some notice that they have been modified.
[1]
Piotr A. Domanski,et al.
Performance of a residential heat pump operating in the cooling mode with single faults imposed
,
2009
.
[2]
Piotr A. Domanski,et al.
Performance of a Residential Heat Pump Operating in the Cooling Mode With Single Faults Imposed | NIST
,
2006
.
[3]
Piotr A. Domanski,et al.
Cooling Mode Fault Detection And Diagnosis Method For A Residential Heat Pump | NIST
,
2008
.
[4]
P. Domanski,et al.
Heating Mode Performance Measurements For A Residential Heat Pump With Single-Faults Imposed
,
2009
.
[5]
Piotr A. Domanski,et al.
Performance of a Residential Heat Pump Operating in the Cooling Mode with Single Faults Imposed (NISTIR 7350)
,
2006
.
[6]
Todd M. Rossi,et al.
A Statistical, Rule-Based Fault Detection and Diagnostic Method for Vapor Compression Air Conditioners
,
1997
.
[7]
James E. Braun.
Automated Fault Detection and Diagnostics for Vapor Compression Cooling Equipment
,
2003
.
[8]
Piotr A. Domanski,et al.
Development of the reference model for a residential heat pump system for cooling mode fault detection and diagnosis
,
2010
.
[9]
Piotr A. Domanski,et al.
Residential Heat Pump Heating Performance with Single Faults Imposed
,
2011
.