A Sub-A Ultrasonic Wake-Up Trigger with Addressing Capability for Wireless Sensor Nodes

Wireless sensor nodes spend most of the time waiting either for sensed data or for packets to be routed to the sink. While on board, sensors can raise hardware interrupts to trigger the wake-up of the processor, incoming packets require the radio module to be turned on in order to be properly received and processed; thus, reducing the effectiveness of dynamic power management and exposing the node to unintended packets cause energy waste. The capability of triggering the wake-up of a node over the air would makes it possible to keep the entire network asleep and to wake up the nodes along a path to the sink whenever there is a packet to transmit. This paper presents an ultrasonic wake-up trigger for ultra-low-power wireless sensor nodes developed as a plug-in module for VirtualSense motes. The module supports a simple out-of-band addressing scheme to enable the selective wake-up of a target node. In addition, it makes it possible to exploit the propagation speed of ultrasonic signals to perform distance measurements. The paper outlines the design choices, reports the results of extensive measurements, and discusses the additional degrees of freedom introduced by ultrasonic triggering in the power-state diagram of VirtualSense.

[1]  Stefan Mahlknecht,et al.  An Ultra Low Power Wakeup Receiver for Wireless Sensor Nodes , 2009, 2009 Third International Conference on Sensor Technologies and Applications.

[2]  S. Gambini,et al.  A 52 $\mu$ W Wake-Up Receiver With $-$ 72 dBm Sensitivity Using an Uncertain-IF Architecture , 2009, IEEE Journal of Solid-State Circuits.

[3]  Kofi A. A. Makinwa,et al.  A 2.4GHz 830pJ/bit duty-cycled wake-up receiver with −82dBm sensitivity for crystal-less wireless sensor nodes , 2010, 2010 IEEE International Solid-State Circuits Conference - (ISSCC).

[4]  Raja Jurdak,et al.  High sensitivity wake-up radio using spreading codes: design, evaluation, and applications , 2011, EURASIP J. Wirel. Commun. Netw..

[5]  R. van Langevelde,et al.  An ultra-low-power 868/915 MHz RF transceiver for wireless sensor network applications , 2009, 2009 IEEE Radio Frequency Integrated Circuits Symposium.

[6]  Hari Balakrishnan,et al.  6th ACM/IEEE International Conference on on Mobile Computing and Networking (ACM MOBICOM ’00) The Cricket Location-Support System , 2022 .

[7]  Michele Magno,et al.  Analytic comparison of wake-up receivers for WSNs and benefits over the wake-on radio scheme , 2012, PM2HW2N '12.

[8]  Xiaoyan Wang,et al.  A 2.4GHz/915MHz 51µW wake-up receiver with offset and noise suppression , 2010, 2010 IEEE International Solid-State Circuits Conference - (ISSCC).

[9]  Emanuel M. Popovici,et al.  Nano-Power Wireless Wake-Up Receiver With Serial Peripheral Interface , 2011, IEEE Journal on Selected Areas in Communications.

[10]  Chuan Yi Tang,et al.  A 2.|E|-Bit Distributed Algorithm for the Directed Euler Trail Problem , 1993, Inf. Process. Lett..

[11]  Sébastien Roy,et al.  Low-Power Wake-Up Radio for Wireless Sensor Networks , 2010, Mob. Networks Appl..

[12]  Thomas Herndl,et al.  A 2.4µW Wake-up Receiver for wireless sensor nodes with −71dBm sensitivity , 2011, 2011 IEEE International Symposium of Circuits and Systems (ISCAS).

[13]  Michele Magno,et al.  An energy efficient multimodal Wireless Video Sensor Network with eZ430–RF2500 modules , 2010, 5th International Conference on Pervasive Computing and Applications.

[14]  Jan M. Rabaey,et al.  Power-efficient rendez-vous schemes for dense wireless sensor networks , 2004, 2004 IEEE International Conference on Communications (IEEE Cat. No.04CH37577).

[15]  Roger Wattenhofer,et al.  SpiderBat: Augmenting wireless sensor networks with distance and angle information , 2011, Proceedings of the 10th ACM/IEEE International Conference on Information Processing in Sensor Networks.

[16]  Alessandro Bogliolo,et al.  Virtual Sense: A Java-Based Open Platform for Ultra-Low-Power Wireless Sensor Nodes , 2012, Int. J. Distributed Sens. Networks.

[17]  Adam Dunkels,et al.  Contiki - a lightweight and flexible operating system for tiny networked sensors , 2004, 29th Annual IEEE International Conference on Local Computer Networks.

[18]  Leonhard M. Reindl,et al.  Low power wake-up receiver for wireless sensor nodes , 2010, 2010 Sixth International Conference on Intelligent Sensors, Sensor Networks and Information Processing.

[19]  Jiannong Cao,et al.  TelosW: Enabling ultra-low power wake-on sensor network , 2010, 2010 Seventh International Conference on Networked Sensing Systems (INSS).

[20]  Jie Gao,et al.  Geometric algorithms for sensor networks , 2012, Philosophical Transactions of the Royal Society A: Mathematical, Physical and Engineering Sciences.

[21]  Peter R. Kinget,et al.  A 4.4-$\mu$ W Wake-Up Receiver Using Ultrasound Data , 2013, IEEE Journal of Solid-State Circuits.

[22]  Guido Dolmans,et al.  A 915MHz ultra-low power wake-up receiver with scalable performance and power consumption , 2011, 2011 Proceedings of the ESSCIRC (ESSCIRC).