Residence time distribution and back-mixing in a tubular electrochemical reactor operated with different inlet flow velocities, to remove Cr(VI) from wastewater

In Mexico, the concentration of Cr(VI) in plating industries wastewater is well above Mexican environmental regulations (0.5 mg/L). The electrochemical Cr(VI) reduction, using iron electrodes has been an alternative process, which has been applied with success to remove Cr(VI) from wastewaters. However, few studies have been performed to evaluate the flow field behavior into the electrochemical reactors. In this work, tests at a novel tubular electrochemical reactor were performed. Five different inlet flow velocities with three different inlet positions (central, lateral and tangential inlets) were tested to evaluate their effect on the reactor performance. To study the flow field behavior throughout the reactor, CFD simulations were carried out. The results showed that at low inlet velocities, the reactor dispersion has strong dependence on the inlet position. On the other hand, when the reactor was operated at higher inlet velocities, the dispersion is reduced and presented similar values for the three reactor inlets. As a consequence of the dispersion reduction in the reactor, the residence time required to reduce the Cr(VI) concentration from 1000 mg/L to <0.5 mg/L, can be decreased until 20%.

[1]  C. Breslin,et al.  Reduction of hexavalent chromium at a polypyrrole-coated aluminium electrode: Synergistic interactions , 2004 .

[2]  S. A. Martínez-Delgadillo,et al.  Performance of a tubular electrochemical reactor, operated with different inlets, to remove Cr(VI) from wastewater , 2010, Comput. Chem. Eng..

[3]  N. Brandon,et al.  Growth kinetics of bubbles electrogenerated at microelectrodes , 1985 .

[4]  R. Aguilar,et al.  Removal of chromium hexavalent from rinsing chromating waters electrochemical reduction in a laboratory pilot plant. , 2004, Water science and technology : a journal of the International Association on Water Pollution Research.

[5]  M. G. Rodríguez,et al.  Removal of Cr(VI) from Wastewaters in a Tubular Electrochemical Reactor , 2005, Journal of environmental science and health. Part A, Toxic/hazardous substances & environmental engineering.

[6]  M. Fleischmann,et al.  Effect of gas evolution on dispersion in an electrochemical reactor , 1993 .

[7]  Jyeshtharaj B. Joshi,et al.  Residence Time Distribution and Flow Patterns in the Single-Phase Annular Region of Annular Centrifugal Extractor , 2009 .

[8]  P. V. Danckwerts.  Continuous flow systems , 1953 .

[9]  Jyeshtharaj B. Joshi,et al.  Computational Flow Modeling and Visualization in the Annular Region of Annular Centrifugal Extractor , 2007 .

[10]  C. Rajagopal,et al.  Electrochemical removal of chromium from wastewater by using carbon aerogel electrodes. , 2004, Water research.

[11]  P. V. Danckwerts.  Continuous flow systems. Distribution of residence times , 1995 .

[12]  Steffen Hardt,et al.  Simulation of helical flows in microchannels , 2004 .

[13]  C. Polprasert,et al.  Electrochemical precipitation of chromium (Cr6+) from an electroplating wastewater , 1995 .

[14]  D. Stamatialis,et al.  Electrochemical reduction of dilute chromate solutions on carbon felt electrodes , 2006 .

[15]  João Jaime Iess,et al.  Computational Fluid Dynamics (CFD) Analysis of Cyclone Separators Connected in Series , 2008 .

[16]  Yusuf Chisti,et al.  Mixing in bubble columns: a new approach for characterizing dispersion coefficients , 2004 .

[17]  Fernando J. Muzzio,et al.  Using CFD to understand chaotic mixing in laminar stirred tanks , 2002 .

[18]  Jyeshtharaj B. Joshi,et al.  Axial mixing in laminar pipe flows , 2004 .

[19]  O. Levenspiel.  Chemical Reaction Engineering , 1972 .

[20]  Frank C. Walsh,et al.  Conversion expressions for electrochemical reactors which operate under mass transport controlled reaction conditions. Part I: batch reactor, PFR and CSTR , 1998 .