Performance evaluation of conducting polymer paints as radar absorbing materials (RAM)

The efficiency and performance of recently developed RAM (radar absorbing materials) based on conducting polymer paints has been investigated in the range of 8-12 GHz. The used conducting polymer in the paint formulations is the polyaniline doped with two different acids: dodecylbenzene sulfonic acid (DBSA), and camphorsulfonic acid (CSA). In practice, RAM ought to be effective over a range of incidence angles; hence, this paper presents reflectivity measurements using NRL arch and radar cross section techniques, in an anechoic chamber. The RAM manufacture and its characterization were carried out at the Material Division of the Space Aeronautical Institute (IAE)/CTA-Defense Department. The results show that the attenuation and the efficiency of the microwave absorbing paints are dependent on their composition (type of polyaniline), their thickness and the incident angle of radiation.

[1]  M. Paoli,et al.  Elastic polyaniline with EPDM and dodecylbenzenesulfonic acid as plasticizers , 2001 .

[2]  M. C. Rezende,et al.  Radar cross section measurements (8-12 GHz) of flat plates painted with microwave absorbing materials , 2001, Proceedings of the 2001 SBMO/IEEE MTT-S International Microwave and Optoelectronics Conference. (Cat. No.01TH8568).

[3]  R. Faez,et al.  Electromagnetic behavior of radar absorbing materials based on conducting polymers , 2001, Proceedings of the 2001 SBMO/IEEE MTT-S International Microwave and Optoelectronics Conference. (Cat. No.01TH8568).

[4]  E. Freeman.  Interference Suppression Techniques for Microwave Antennas and Transmitters , 1999 .

[5]  I. Youngs,et al.  Broadband dielectric spectroscopy of conducting polyaniline , 1998 .

[6]  B. Wessling.  Dispersion as the link between basic research and commercial applications of conductive polymers (polyaniline) , 1998 .

[7]  M. Zilberman,et al.  Conductive Blends of Thermally Dodecylbenzene Sulfonic Acid-Doped Polyaniline with Thermoplastic Polymers , 1997 .

[8]  H. Nalwa.  Conductive polymers : synthesis and electrical properties , 1997 .

[9]  Barry Chambers,et al.  Characterisation of conducting polymer-loaded composite materials at oblique incidence and their application in radar absorbers , 1995 .

[10]  P. Hourquebie.  Influence of structural characteristics of conducting polymers on their microwave properties , 1994 .

[11]  Patrick Hourquebie,et al.  Microwave absorbing materials based on conducting polymers , 1993 .

[12]  P. Hourquebie,et al.  Influence of Structural Parameters of Conducting Polymers on their Microwave Properties , 1993 .

[13]  Barry Chambers,et al.  Large area conducting polymer composites and their use in microwave absorbing material , 1992 .