An Experimental Study of Aerospace Material during Fabrication of V Groove using WEDM

In this experimental study, the machining parameter s, tool electrode, current, pulse on time, pulse of time, wire feed and wire tension has been studied using Incone l-625 as work piece in Wire electrical discharge ma chining (WEDM). The optimization of these parameters is very crucial for the greatest manufacturing results and product ion at the lowest cost. In order to get the maximum output from these industries, the material removal rate and surface roughness should be optimized. The experiment has been executed using Ta uchi’s mixed array L18 (2 *3) and ANOVA technique using MINITAB software to determine the significant and no-significant parameters. This paper demonstrates t hat the WEDM process parameters can be adjusted for the ach ievement of better MRR and SR simultaneously.

[1]  Optimization of cryogenic cooled EDM process parameters using grey relational analysis , 2014 .

[2]  Shane Y. Hong,et al.  New cooling approach and tool life improvement in cryogenic machining of titanium alloy Ti-6Al-4V , 2001 .

[3]  Harpreet Singh,et al.  Effect of Pulse On/Pulse Off Time On Machining Of AISI D3 Die Steel Using Copper And Brass Electrode In EDM , 2012 .

[4]  O. Belgassim,et al.  Investigation of the influence of EDM parameters on the overcut for AISI D3 tool steel , 2012 .

[5]  I. Rajendran,et al.  Optimization of Deep Cryogenic Treatment to Reduce Wear Loss of 4140 Steel , 2012 .

[6]  M. Manjaiah,et al.  Parametric optimization of MRR and surface roughness in wire electro discharge machining (WEDM) of D2 steel using Taguchi-based utility approach , 2016 .

[7]  Pulak M. Pandey,et al.  Study of ultrasonic assisted cryogenically cooled EDM process using sintered (Cu–TiC) tooltip , 2013 .

[8]  S. S. Karidkar,et al.  Analysis of Response Variables in WEDM of Inconel 718 Using Taguchi Technique , 2016 .

[9]  P. Hariharan,et al.  Machining Performance of Cryogenically Treated Electrodes in Microelectric Discharge Machining: A Comparative Experimental Study , 2013 .

[10]  Souren Mitra,et al.  Experimental investigation on die corner accuracy for wire electrical discharge machining of Monel 400 alloy , 2012 .

[11]  M. I. Ahmed,et al.  Improving tool life using cryogenic cooling , 2008 .

[12]  K. Rajurkar,et al.  The Effects of Cold and Cryogenic Treatments on the Machinability of Beryllium-CopperAlloy in Electro Discharge Machining , 2011 .