A Study of Efficiency in a Reduced Matrix Converter for Offshore Wind Farms

Reduced matrix converter (RMC) is a convenient topology for offshore wind farm due to its potential to reduce the size and weight of the converter, to improve the reliability by removing the electrolytic capacitor, and to increase the efficiency inherent to less stages of conversion. Moreover, it is a very flexible topology which permits different types of operation with a simpler modulation compared with conventional three-phase matrix converter. This paper investigates different modulation strategies applied to RMC for offshore wind farms, focused on efficiency improvement of the entire convention system. Simulation results using a detailed loss model for high-power level are presented. Four cases are investigated according to the modulation strategies (space vector modulation and carrier-based modulation) and the operation principle (current source converter or voltage source converter). Losses in the clamp circuit are also calculated. Different wind velocities are considered in the simulations. Results show that current source operation with space vector modulation presents minimum losses at nominal wind velocity. This operation is suitable for series connection of offshore wind farms which has been reported as the most efficient alternative from the grid losses point of view.

[1]  Michael Braun,et al.  Passive protection strategy for a drive system with a matrix converter and an induction machine , 2002, IEEE Trans. Ind. Electron..

[2]  Stefan Lundberg.  Wind Farm Configuration and Energy Efficiency Studies - Series DC versus AC Layouts , 2006 .

[3]  Frede Blaabjerg,et al.  Using reverse blocking IGBTs in power converters for adjustable speed drives , 2003 .

[4]  Ned Mohan,et al.  Direct-Matrix-Converter-Based Drive for a Three-Phase Open-End-Winding AC Machine With Advanced Features , 2010, IEEE Transactions on Industrial Electronics.

[5]  S. Meier,et al.  Benchmark of Annual Energy Production for Different Wind Farm Topologies , 2005, 2005 IEEE 36th Power Electronics Specialists Conference.

[6]  Richard W G Bucknall,et al.  On the Conceptual Design and Performance of a Matrix Converter for Marine Electric Propulsion , 2010, IEEE Transactions on Power Electronics.

[7]  Enrique J. Dede,et al.  A bidirectional and isolated three-phase rectifier with soft-switching operation , 2005, IEEE Transactions on Industrial Electronics.

[8]  Roberto Cárdenas,et al.  Experimental Validation of a Space-Vector-Modulation Algorithm for Four-Leg Matrix Converters , 2011, IEEE Transactions on Industrial Electronics.

[9]  Meng Yeong Lee,et al.  Space-Vector Modulated Multilevel Matrix Converter , 2010, IEEE Transactions on Industrial Electronics.

[10]  A. Odaka,et al.  A novel approach to practical matrix converter motor drive system with reverse blocking IGBT , 2004, IEEE Transactions on Power Electronics.

[11]  Eduardo P. Wiechmann,et al.  On the Efficiency of Voltage Source and Current Source Inverters for High-Power Drives , 2008, IEEE Transactions on Industrial Electronics.

[12]  L. Empringham,et al.  Comparison of bi-directional switch components for direct AC-AC converters , 2004, 2004 IEEE 35th Annual Power Electronics Specialists Conference (IEEE Cat. No.04CH37551).

[13]  M. Swamy,et al.  Present state and a futuristic vision of motor drive technology , 2008, 2008 11th International Conference on Optimization of Electrical and Electronic Equipment.

[14]  A.M. Knight,et al.  A review of power converter topologies for wind generators , 2005, IEEE International Conference on Electric Machines and Drives, 2005..

[15]  Dragan Jovcic,et al.  Offshore wind farm with a series multiterminal CSI HVDC , 2008 .

[16]  C. W. Tipton,et al.  High-Density Nanocrystalline Core Transformer for High-Power High-Frequency Resonant Converter , 2008, IEEE Transactions on Industry Applications.

[17]  Patrick Wheeler,et al.  Analytical and Experimental Evaluation of a WECS Based on a Cage Induction Generator Fed by a Matrix Converter , 2011, IEEE Transactions on Energy Conversion.

[18]  P.W. Wheeler,et al.  High-frequency multimegawatt polyphase resonant power conditioning , 2005, IEEE Transactions on Plasma Science.

[19]  Marta Molinas,et al.  Impact of operation principle on the losses of a reduced matrix converter for offshore wind parks , 2010, 2010 IEEE International Symposium on Industrial Electronics.

[20]  Mustansir H. Kheraluwala,et al.  Coaxially wound transformers for high-power high-frequency applications , 1992 .

[21]  L. Heinemann,et al.  An actively cooled high power, high frequency transformer with high insulation capability , 2002, APEC. Seventeenth Annual IEEE Applied Power Electronics Conference and Exposition (Cat. No.02CH37335).

[22]  Marta Molinas,et al.  Comparative investigation of losses in a reduced matrix converter for off-shore wind turbines , 2010 .

[23]  Thomas Ackermann,et al.  Loss evaluation of HVAC and HVDC transmission solutions for large offshore wind farms , 2006 .

[24]  Shoji Nishikata,et al.  A New Interconnecting Method for Wind Turbine/Generators in a Wind Farm and Basic Performances of the Integrated System , 2010, IEEE Transactions on Industrial Electronics.

[25]  Muhammad H. Rashid,et al.  Power Electronics Handbook: Devices, Circuits and Applications , 2010 .

[26]  Brian F. Snyder,et al.  Ecological and economic cost-benefit analysis of offshore wind energy , 2009 .

[27]  M. Molinas,et al.  Cluster Interconnection of Offshore Wind Farms Using Direct AC High Frequency Links , 2009 .

[28]  Marta Molinas,et al.  High frequency wind energy conversion from the ocean , 2010, The 2010 International Power Electronics Conference - ECCE ASIA -.

[29]  José R. Rodríguez,et al.  Matrix converters: a technology review , 2002, IEEE Trans. Ind. Electron..

[30]  Patrick Wheeler,et al.  Control of the Reactive Power Supplied by a WECS Based on an Induction Generator Fed by a Matrix Converter , 2009, IEEE Transactions on Industrial Electronics.

[31]  M. Molinas,et al.  A power conversion system for offshore wind parks , 2008, 2008 34th Annual Conference of IEEE Industrial Electronics.

[32]  J. Itoh,et al.  Analysis of loss and junction temperature in power semiconductors of the matrix converter using simple simulation methods , 2004, Conference Record of the 2004 IEEE Industry Applications Conference, 2004. 39th IAS Annual Meeting..

[33]  Lena Max,et al.  Design and control of a DC collection grid for a wind farm , 2009 .

[34]  W.L. Kling,et al.  HVDC Connection of Offshore Wind Farms to the Transmission System , 2007, IEEE Transactions on Energy Conversion.

[35]  Marta Molinas,et al.  Power Collection and Integration on the Electric Grid from Offshore Wind Parks , 2008 .

[36]  J. Itoh,et al.  Realization of High Efficiency AC link Converter System based on AC/AC Direct Conversion Techniques with RB-IGBT , 2006, IECON 2006 - 32nd Annual Conference on IEEE Industrial Electronics.

[37]  R. Liu,et al.  A study of volume and weight vs. frequency for high-frequency transformers , 1993, Proceedings of IEEE Power Electronics Specialist Conference - PESC '93.

[38]  J.-M. Meyer,et al.  A DC hybrid circuit breaker with ultra-fast contact opening and integrated gate-commutated thyristors (IGCTs) , 2006, IEEE Transactions on Power Delivery.

[39]  Jason Cotrell,et al.  A Preliminary Evaluation of a Multiple-Generator Drivetrain Configuration for Wind Turbines , 2002 .

[40]  Keping You,et al.  Over-voltage protection using power Zener diode for matrix converter and matrix-Z-source converter , 2009, 2009 International Conference on Power Electronics and Drive Systems (PEDS).

[41]  Marta Molinas,et al.  Coordinated control of series‐connected offshore wind park based on matrix converters , 2012 .

[42]  Lee Empringham,et al.  Control and Implementation of a Matrix-Converter-Based AC Ground Power-Supply Unit for Aircraft Servicing , 2010, IEEE Transactions on Industrial Electronics.

[43]  William Gerard Hurley,et al.  Optimized transformer design: inclusive of high-frequency effects , 1998 .

[44]  Edison Roberto Cabral da Silva,et al.  Single-Phase AC–DC–AC Three-Level Three-Leg Converter , 2010, IEEE Transactions on Industrial Electronics.