Distributed MEMS true-time delay phase shifters and wide-band switches

Wide-band switches and true-time delay (TTD) phase shifters have been developed using distributed microelectromechanical system (MEMS) transmission lines for applications in phased-array and communication systems. The design consists of a coplanar waveguide (CPW) transmission line (W=G=100 /spl mu/m) fabricated on a 500 /spl mu/m quartz substrate with fixed-fixed beam MEMS bridge capacitors placed periodically over the transmission line, thus creating a slow-wave structure. A single analog control voltage applied to the center conductor of the CPW line can vary the phase velocity of the loaded line by pulling down on the MEMS bridges to increase the distributed capacitive loading. The resulting change in the phase velocity yields a TTD phase shift. Alternatively, the control voltage can be increased beyond the pull-down voltage of the MEMS bridges such that the capacitive loading greatly increases and shorts the line to ground. The measured results demonstrate 0-60 GHz TTD phase shifters with 2 dB loss/118/spl deg/ phase shift at 60 GHz (/spl sim/4.5-ps TTD) and 1.8 dB loss/84/spl deg/ phase shift at 40 GHz. Also, switches have been demonstrated with an isolation of better than 40 dB from 21 to 40 and 40 to 60 GHz. In addition, a transmission-line model has been developed, which results in very close agreement with the measured data for both the phase shifters and switches. The pull-down voltage is 10-23 V, depending on the residual stress in the MEMS bridge. To our knowledge, this paper presents the first wide-band TTD MEMS phase shifters and wide-band switches to date.

[1]  D. Rutledge,et al.  INTEGRATED-CIRCUIT ANTENNAS. , 1983 .

[2]  D. Pozar.  Microwave Engineering , 1990 .

[3]  Lawrence E. Larson,et al.  Micromachined microwave actuator (MIMAC) technology-a new tuning approach for microwave integrated circuits , 1991, IEEE 1991 Microwave and Millimeter-Wave Monolithic Circuits Symposium. Digest of Papers.

[4]  S. Senturia,et al.  Self-consistent simulation and modelling of electrostatically deformed diaphragms , 1994, Proceedings IEEE Micro Electro Mechanical Systems An Investigation of Micro Structures, Sensors, Actuators, Machines and Robotic Systems.

[5]  M. Rodwell,et al.  Active and nonlinear wave propagation devices in ultrafast electronics and optoelectronics , 1994, Proc. IEEE.

[6]  C. Goldsmith,et al.  Micromechanical membrane switches for microwave applications , 1995, Proceedings of 1995 IEEE MTT-S International Microwave Symposium.

[7]  Gabriel M. Rebeiz,et al.  High performance microshield line components , 1995 .

[8]  M. F. Chang,et al.  A Surface Micromachined Miniature Switch For Telecommunications Applications With Signal Frequencies From DC Up To 4 Ghz , 1995, Proceedings of the International Solid-State Sensors and Actuators Conference - TRANSDUCERS '95.

[9]  S. Eshelman,et al.  Characteristics of micromachined switches at microwave frequencies , 1996, 1996 IEEE MTT-S International Microwave Symposium Digest.

[10]  D. Choudhury,et al.  High-performance W-band GaAs PIN diode single-pole triple-throw switch CPW MMIC , 1997, 1997 IEEE MTT-S International Microwave Symposium Digest.

[11]  G. Ponchak.  Development of passive components for millimeter-wave circuits. , 1997 .

[12]  C. Nguyen,et al.  Micromechanical electrostatic K-band switches , 1998, 1998 IEEE MTT-S International Microwave Symposium Digest (Cat. No.98CH36192).