Vaporization of bulk metals into single-digit nanoparticles by non-thermal plasma filaments in atmospheric pressure dielectric barrier discharges

Abstract A compact, inexpensive and simple dielectric barrier discharge (DBD) design is presented with related electro-thermal properties for the production of metal nanoparticles. Nanoparticle formation and growth mechanisms are depicted from size distributions and chemical analyses of particles collected just after the 70 kHz DBD in nitrogen. At first, it is confirmed that the initial local vapor flux is produced from the spots of interaction between plasma filaments and different metal electrodes (Au, Ag, and Cu). Amorphous and crystalline pure metal primary nanoparticles with diameters below 5 nm are then produced by physical nucleation in expanding vapors jets. Finally, some small agglomerates with diameters still below 5 nm are also formed by ballistic agglomeration of a fraction of these primary particles. This happens at the end of the vapor jet expansion, as well as after the production during the transit between subsequent filaments in the DBD. The first local agglomeration step can be limited at reduced energy per filament by lowering the initial vapor flux in smaller gaps, while the second growth step depends on the transit time in the DBD. Hence, such “low” energy plasma filaments (up to a few tens of µJ) lower the initial vapor flux to control the agglomeration. DBD were thus successfully tested for the production of tailored nanoparticles with tunable size, controlled morphology of spherical agglomerates and the same composition as the metal electrode. The production per unit energy (mol J −1 ) is related to both plasma and material properties. Besides, neglecting vapor and nanoparticles losses, the mass production rate (g s −1 ) depends on the input power related to the product of the energy controlling the production per filament times the number of filaments per second, for any given material. This non-thermal plasma process presents great potentialities for nano-technologies since it is performed at atmospheric pressure and can be used to reach size-dependent properties of nano-materials, without any gaseous precursor or solvent.

[1]  G. Kasper.  Electrostatic dispersion of homopolar charged aerosols , 1981 .

[2]  F. Gensdarmes,et al.  Electrical properties of airborne nanoparticles produced by a commercial spark-discharge generator , 2010 .

[3]  M. Hori,et al.  The 2012 Plasma Roadmap , 2012 .

[4]  Song Huat Yeo,et al.  Electro-thermal modelling of anode and cathode in micro-EDM , 2007 .

[5]  T. Itina,et al.  Nanoparticle formation by laser ablation in air and by spark discharges at atmospheric pressure , 2013 .

[6]  Massoud Massoudi Farid,et al.  Anti-agglomeration of spark discharge-generated aerosols via unipolar air ions , 2014 .

[7]  Jean-Pascal Borra,et al.  Electrical characterization of microdischarges produced by dielectric barrier discharge in dry air at atmospheric pressure , 2006 .

[8]  Davide Bleiner,et al.  Effect of ambient pressure on laser ablation and plume expansion dynamics: A numerical simulation , 2006 .

[9]  Irving Langmuir,et al.  The Vapor Pressure of Metallic Tungsten , 1913 .

[10]  J. Borra,et al.  Atmospheric pressure plasmas for aerosols processes in materials and environment , 2009 .

[11]  F. Bastien,et al.  Physics and applications of atmospheric non-thermal air plasma with reference to environment , 2009 .

[12]  S. S. Harilal,et al.  Emission features and expansion dynamics of nanosecond laser ablation plumes at different ambient pressures , 2014 .

[13]  Xavier Bonnin,et al.  Subroutines for some plasma surface interaction processes: physical sputtering, chemical erosion, radiation enhanced sublimation, backscattering and thermal evaporation , 2004, Comput. Phys. Commun..

[14]  J. Borra,et al.  Kinematics of charged nanometric particles in silent discharges , 2005 .

[15]  Ion and neutral energy distributions to the MgO surface and sputtering rates in plasma display panel cells , 2006, IEEE Transactions on Plasma Science.

[16]  A. Murphy,et al.  Numerical analysis of fume formation mechanism in arc welding , 2010 .

[17]  Yuji Okita,et al.  Polarity Effect Of Silent Discharge , 1995 .

[18]  G. Schmid.  Nanoparticles : from theory to application , 2010 .

[19]  V. Alexiades,et al.  The role of mass removal mechanisms in the onset of ns-laser induced plasma formation , 2013 .

[20]  C. Housiadas,et al.  Thermophoretic Deposition in Tube Flow , 2005 .

[21]  V. Rudyak,et al.  Measurements of the temperature dependent diffusion coefficient of nanoparticles in the range of 295–600 K at atmospheric pressure , 2009 .

[22]  U. Baltensperger,et al.  In situ characterization and structure modification of agglomerated aerosol particles , 1995 .

[23]  Jean-Pascal Borra,et al.  Nucleation and aerosol processing in atmospheric pressure electrical discharges: powders production, coatings and filtration , 2006 .

[24]  H. Horvath,et al.  A low-voltage spark generator for production of carbon particles , 2003 .

[25]  Anthony B. Murphy,et al.  The effects of metal vapour in arc welding , 2010 .

[26]  H. Nirschl,et al.  Distinguishing between aggregates and agglomerates of flame-made TiO2 by high-pressure dispersion , 2008 .

[27]  T. Belmonte,et al.  Synthesis of platinum embedded in amorphous carbon by micro-gap discharge in heptane , 2013 .

[28]  Gerhard J. Pietsch,et al.  The development of dielectric barrier discharges in gas gaps and on surfaces , 2000 .

[29]  Zoran Falkenstein,et al.  Microdischarge behaviour in the silent discharge of nitrogen - oxygen and water - air mixtures , 1997 .

[30]  T. Hashimoto,et al.  Penetration of nanometer-sized aerosol particles through wire screen and laminar flow tube , 1997 .

[31]  Thierry Belmonte,et al.  Nanoscience with non-equilibrium plasmas at atmospheric pressure , 2011 .

[32]  O. Aguerre,et al.  Nano-droplet ejection and nucleation of materials submitted to non-thermal plasma filaments , 2011 .

[33]  F. Llewellyn Jones,et al.  Electrode Erosion by Spark Discharges , 1950 .

[34]  Françoise Massines,et al.  Atmospheric Pressure Low Temperature Direct Plasma Technology: Status and Challenges for Thin Film Deposition , 2012 .

[35]  Guixin Zhang,et al.  The effect of air plasma on barrier dielectric surface in dielectric barrier discharge , 2010 .

[36]  E. Gamaly.  The physics of ultra-short laser interaction with solids at non-relativistic intensities , 2011 .

[37]  P K Hopke,et al.  On improving the validity of wire screen "unattached" fraction Rn daughter measurements. , 1989, Health physics.

[38]  B. Eliasson,et al.  Modeling and applications of silent discharge plasmas , 1991 .

[39]  S. Pratsinis,et al.  Coagulation of highly concentrated aerosols , 2009 .

[40]  N. Jidenko,et al.  Temperature profiles in filamentary dielectric barrier discharges at atmospheric pressure , 2010 .

[41]  M. Abbaoui,et al.  Numerical modelling of thermal ablation phenomena due to a cathodic spot , 2000 .

[42]  M. Goldman,et al.  Electrical characterization of gas discharges using a numerical treatment. Application to dielectric barrier discharges , 2002 .

[43]  Guixin Zhang,et al.  Effect of dielectric barrier discharge on semiconductor Si electrode surface , 2010 .

[44]  J. Vendel,et al.  Influence of Carrier Gas Flow Rate, Laser Repetition Rate, and Fluence on the Size Distribution and Number of Nanoparticles Generated Per Laser Shot During Paint Laser Ablation , 2011 .

[45]  Mansoo Choi,et al.  A study of pin-to-plate type spark discharge generator for producing unagglomerated nanoaerosols , 2012 .

[46]  Jae Hong Park,et al.  Spark generation of monometallic and bimetallic aerosol nanoparticles , 2008 .

[47]  D. Vollath,et al.  The Microwave plasma process – a versatile process to synthesise nanoparticulate materials , 2006 .

[48]  Toivo T. Kodas,et al.  Aerosol Processing of Materials , 1998 .

[49]  R. Russo,et al.  Experimental and theoretical studies of particle generation after laser ablation of copper with a background gas at atmospheric pressure , 2007 .

[50]  Pierre Freton,et al.  Thermal plasma modelling , 2005 .

[51]  B. Smirnov.  Clusters in expanding plasma , 1993 .

[52]  J. Borra.  Charging of aerosol and nucleation in atmospheric pressure electrical discharges , 2008 .

[53]  A. Schnettler,et al.  Spark discharge particle generator for laser Doppler anemometry , 1980 .

[54]  A. Lasagni,et al.  Quantitative investigation of material erosion caused by high-pressure discharges in air and nitrogen , 2004 .

[55]  J. Boeuf,et al.  Energy balance in a nonequilibrium weakly ionized nitrogen discharge , 1986 .

[56]  Synthesis and On-line Size Control of Silicon Quantum Dots , 2011 .