Thermoelectric Exhaust Heat Recovery with Heat Pipe-Based Thermal Control

Heat pipe (HP)-based heat exchangers can be used for very low resistance heat transfer between a hot and a cold source. Their operating temperature depends solely on the boiling point of their working fluid, so it is possible to control the heat transfer temperature if the pressure of the HP can be adjusted. This is the case of the variable conductance HPs (VCHP). This solution makes VCHPs ideal for the passive control of thermoelectric generator (TEG) temperature levels. The present work assesses, both theoretically and experimentally, the merit of the aforementioned approach. A thermal and electrical model of a TEG with VCHP assist is proposed. Experimental results obtained with a proof of concept prototype attached to a small single-cylinder engine are presented and used to validate the model. It was found that the HP heat exchanger indeed enables the TEG to operate at a constant, optimal temperature in a passive and safe way, and with a minimal overall thermal resistance, under part load, it effectively reduces the active module area without deprecating the temperature level of the active modules.

[1]  Philippe Wenger,et al.  New Trends in Mechanism and Machine Science , 2013 .

[2]  David Reay,et al.  Heat pipes : theory, design and applications , 2014 .

[3]  H. W..  The Internal Combustion Engine , 1923, Nature.

[4]  José Higino Correia,et al.  A planar thermoelectric power generator for integration in wearable microsystems , 2010 .

[5]  Ji-Hui Yang,et al.  Automotive Applications of Thermoelectric Materials , 2009 .

[6]  José Higino Correia,et al.  Characterization of thermoelectric generators by measuring the load-dependence behavior , 2011 .

[7]  S. D. Probert,et al.  Interstitial materials for controlling thermal conductances across pressed metallic contacts , 1984 .

[8]  F. P. Brito,et al.  Temperature controlled exhaust heat thermoelectric generation , 2012 .

[9]  D. Rowe.  Thermoelectrics Handbook , 2005 .

[10]  Gao Min,et al.  Conversion Efficiency of Thermoelectric Combustion Systems , 2007, IEEE Transactions on Energy Conversion.

[11]  Jorge Martins,et al.  Motores de combustão interna , 2006 .

[12]  John B. Heywood,et al.  Internal combustion engine fundamentals , 1988 .

[13]  Frank P. Incropera,et al.  Fundamentals of Heat and Mass Transfer , 1981 .

[14]  F. P. Brito,et al.  Analysis of four-stroke, Wankel, and microturbine based range extenders for electric vehicles , 2012 .

[15]  C. B. Vining.  An inconvenient truth about thermoelectrics. , 2009, Nature materials.

[16]  L. Bell.  Cooling, Heating, Generating Power, and Recovering Waste Heat with Thermoelectric Systems , 2008, Science.

[17]  S. K. Wang,et al.  A Review of Organic Rankine Cycles (ORCs) for the Recovery of Low-grade Waste Heat , 1997 .

[18]  Saad Mekhilef,et al.  A review on global fuel economy standards, labels and technologies in the transportation sector , 2011 .

[19]  M. Dresselhaus,et al.  New Directions for Low‐Dimensional Thermoelectric Materials , 2007 .