The Impact of Real Geometries on Three-Dimensional Separations in Compressors

This paper considers the effect of small variations in leading edge geometry, leading edge roughness, leading edge fillet, and blade fillet geometry on the three-dimensional separations found in compressor blade rows. The detrimental effects of these separations have historically been predicted by correlations based on global flow parameters, such as blade loading, inlet boundary layer skew, etc., and thus ignoring small deviations such as those highlighted above. In this paper it is shown that this may not be the case and that certain, engine representative geometry deviations can have an effect equivalent to an increase in blade loading of 10%. Experiments were performed at the stator hub of a low-speed, single-stage compressor. The results show that any deviation which causes suction surface transition to move to the leading edge over the first 30% of span will cause a large growth in the size of the hub separation, doubling its impact on loss. The geometry deviations that caused this, and are thus of greatest concern to a designer, are changes in leading edge quality and roughness around the leading edge, which are characteristic of an eroded blade.

[1]  Tom Hynes,et al.  Influence of Surface Roughness on Three-Dimensional Separation in Axial Compressors , 2004 .

[2]  Andrew P. S. Wheeler,et al.  The Effect of Leading-Edge Geometry on Wake Interactions in Compressors , 2009 .

[3]  Reinhard Mönig,et al.  1999 Turbomachinery Committee Best Paper Award: Development of Advanced Compressor Airfoils for Heavy-Duty Gas Turbines— Part II: Experimental and Theoretical Analysis , 2000 .

[4]  J. D. Denton,et al.  The Calculation of Three-Dimensional Viscous Flow Through Multistage Turbomachines , 1992 .

[5]  Heinz-Adolf Schreiber,et al.  Effects of Reynolds Number and free-stream Turbulence on Boundary Layer Transition in a Compressor Cascade , 2002 .

[6]  Martin N. Goodhand,et al.  Compressor Leading Edge Spikes: A New Performance Criterion , 2011 .

[7]  H. Starken,et al.  Off-Design Transition and Separation Behavior of a CDA Cascade , 1996 .

[8]  Tom Hynes,et al.  Three-Dimensional Separations in Axial Compressors , 2005 .

[9]  Reinhard Mönig,et al.  Development of Advanced Compressor Airfoils for Heavy-Duty Gas Turbines: Part II — Experimental and Theoretical Analysis , 1999 .

[10]  Z. S. Spakovszky,et al.  A Criterion for Axial Compressor Hub-Corner Stall , 2008 .

[11]  C. C. Koch,et al.  Loss Sources and Magnitudes in Axial-Flow Compressors , 1976 .

[12]  John Jude Bolger.  Three dimensional design of compressor blades , 1999 .

[13]  Leigh Lapworth,et al.  PADRAM: Parametric Design and Rapid Meshing System for Turbomachinery Optimisation , 2003 .

[14]  W. J. Solomon.  Unsteady boundary layer transition on axial compressor blades , 1996 .

[15]  R. J. Goldstein,et al.  Fluid Mechanics Measurements , 1983 .