Position control Of BLDC motor with modified bipolar PWM for clutch system Of PHEV

Generally, PHEV(plug-in hybrid electric vehicle) is driven by the engine, the primary traction motor, and the secondary auxiliary motor generating the electric power for battery charging. Secondary auxiliary motor should be connected to the engine or separated from the engine by the clutch system. This paper presents the position controller using BLDC motor for the clutch system of PHEV. BLDC motor can be applied to the clutch system in spite of it's low resolution of the position sensor due to high gear ratio between the clutch and the motor. Since the attachment and the detachment between the motor and the engine should be carried out within 0.3 seconds, the position controller with fast acceleration and deceleration must be implemented. For the torque control with braking operation for the BLDC motor, the modified bipolar PWM method with low current ripple compared to the conventional unipolar PWM is proposed. The position control performance of the BLDC motor for clutch system is verified through the simulation and experiments.

[1]  Thomas M. Jahns,et al.  Pulsating torque minimization techniques for permanent magnet AC motor drives-a review , 1996, IEEE Trans. Ind. Electron..

[2]  Guangwei Meng,et al.  Commutation torque ripple reduction in BLDC motor using PWM_ON_PWM mode , 2009, 2009 International Conference on Electrical Machines and Systems.

[3]  Kwang-Woon Lee,et al.  Commutation torque ripple reduction in a position sensorless brushless DC motor drive , 2006, 2004 IEEE 35th Annual Power Electronics Specialists Conference (IEEE Cat. No.04CH37551).

[4]  Hyung-Soo Mok,et al.  Position Controller for Clutch Drive System of PHEV(Plug in Hybrid Electric Vehicle) , 2012 .

[5]  C.-S. Berendsen,et al.  Commutation strategies for brushless DC motors: influence on instant torque , 1990, Fifth Annual Proceedings on Applied Power Electronics Conference and Exposition.

[6]  Hyung-Soo Mok,et al.  Novel PWM Method with Low Ripple Current for Position Control Applications of BLDC Motors , 2011 .

[7]  Y. Chuang,et al.  Analysis of commutation torque ripple using different PWM modes in BLDC motors , 2009, Conference Record 2009 IEEE Industrial & Commercial Power Systems Technical Conference.

[8]  Chen Boshi,et al.  Influences of PWM mode on the current generated by BEMF of switch-off phase in control system of BLDC motor , 2001, ICEMS'2001. Proceedings of the Fifth International Conference on Electrical Machines and Systems (IEEE Cat. No.01EX501).

[9]  Weili Li,et al.  Electrothermal Analysis of Induction Motor With Compound Cage Rotor Used for PHEV , 2010, IEEE Transactions on Industrial Electronics.

[10]  Yongxiang Xu,et al.  Control of a BLDC motor for electromechanical cctuator , 2008, 2008 International Conference on Electrical Machines and Systems.