Dynamic Modelling and Control of Semifree-Piston Motion in a Rotary Diesel Generator Concept

A new semifree-piston rotary generator concept is modelled dynamically and reduced to a single equation for piston stroke motion. This new concept comprises a toroidal-segment piston and cylinder, which orbit on separate generator disks, coupled by a pair of torsion springs to form a balanced mass-elastic system capable of spin. Conventional cyclic combustion takes place in the cylinder causing resonant motion of the disks. A two-part control strategy is proposed and tested by simulation to address the multi-objectives of maximum mechanical power transfer, minimum peak generator torque, and accurate piston top dead center (TDC) position control. A Part I strategy initially assumes that the combustion gas pressure is a function of time only. This produces torque control that follows a stroke velocity feedback law, which maximizes power transfer and implicitly minimizes generator torque, at the same time as power generation. When stroke-dependent gas pressure is introduced, however, the Part I strategy creates an unstable self-excited nonlinear system. The Part II strategy is designed to control piston TDC position and stabilize the response. This uses proportional control of gas pressure rise, assumed possible through fuel injection control and in-cylinder pressure sensing. An ideal-air-standard-dual-combustion two-stroke cycle is then adopted for nonstochastic simulation purposes, excluding the effect of delays and coupled system dynamics. A study is undertaken of a nominal 1.42 l, 200 mm orbit-radius, constant-pressure-scavenged diesel design with three different spring stiffness values. By focusing near the minimum compression ratio for diesel, to give a lower bound on the possible ideal output power, control gains are found that produce stable motion with piston TDC position errors of less than 1%. The power range is from 16 kW to 336 kW, depending mainly on spring stiffness. Since the concept can also store significant kinetic energy, it is potentially attractive as a range-extender for electric vehicles.

[1]  M. Leksell,et al.  Minimizing power pulsations in a free piston energy converter , 2005, 2005 European Conference on Power Electronics and Applications.

[2]  Julian F Dunne,et al.  A split-frequency harmonic balance method for nonlinear oscillators with multi-harmonic forcing , 2006 .

[3]  Jin-Woo An A High Efficiency Direct Instantaneous Torque Control of SRM based on the Nonlinear Model , 2007 .

[4]  John B. Heywood,et al.  Internal combustion engine fundamentals , 1988 .

[5]  Riaz A. Mufti,et al.  Experimental Evaluation of Piston-Assembly Friction Under Motored and Fired Conditions in a Gasoline Engine , 2005 .

[6]  John M. Miller,et al.  Propulsion Systems for Hybrid Vehicles , 2003 .

[7]  Eiji Tomita,et al.  Cycle-resolved measurements of the fuel concentration near a spark plug in a rotary engine using an in situ laser absorption method , 2007 .

[8]  B. V. Librovich Dynamics of Rotary Vane Engine , 2003 .

[9]  Jin Xiao,et al.  Simulation of a Two-Stroke Free-Piston Engine for Electrical Power Generation , 2008 .

[10]  Tor Arne Johansen,et al.  Dynamics and Control of a Free-Piston Diesel Engine , 2003 .

[11]  R. Mikalsen,et al.  A review of free-piston engine history and applications , 2007 .

[12]  Rik W. De Doncker,et al.  Sensorless Direct Instantaneous Torque Control for Switched Reluctance Machines , 2006 .

[13]  R.W. De Doncker,et al.  Sensorless direct instantaneous torque control for switched reluctance machines , 2006, 2005 European Conference on Power Electronics and Applications.

[14]  Jiabin Wang,et al.  Experimental Characterization of a Supercapacitor-Based Electrical Torque-Boost System for Downsized ICE Vehicles , 2007, IEEE Transactions on Vehicular Technology.

[15]  Ilya Kolmanovsky,et al.  Editorial: Special Issue on Control Applications in Automotive Engineering , 2007 .

[16]  T. T. Soong,et al.  Random differential equations in science and engineering , 1974 .

[18]  S. K. Sahoo,et al.  Indirect torque control of switched reluctance motors using iterative learning control , 2005, IEEE Transactions on Power Electronics.

[19]  Paul King,et al.  Time-Frequency Analysis of Single-Point Engine-Block Vibration Measurements for Multiple Excitation-Event Identification , 2009 .

[20]  Zhao Dean,et al.  Novel control system of switched reluctance integrated starter/generator used in vehicle , 2006 .

[22]  Richard Stone,et al.  Introduction to Internal Combustion Engines , 1985, Internal Combustion Engines.

[23]  Masami Sakita A Cat-and-Mouse Type Rotary Engine: Engine Design and Performance Evaluation , 2006 .

[24]  Julian F Dunne,et al.  A model for simulating the instantaneous crank kinematics and total mechanical losses in a multicylinder in-line engine , 2007 .

[25]  R. V. Basshuysen,et al.  Internal Combustion Engine Handbook , 2004 .

[26]  Valéria Hrabovcová,et al.  EQUIVALENT CIRCUIT OF SWITCHED RELUCTANCE GENERATOR BASED ON DC SERIES GENERATOR , 2008 .

[27]  Riaz A. Mufti,et al.  Experimental and Theoretical Study of Instantaneous Engine Valve Train Friction , 2003 .