Design and development of a model-based hardware simulator for photovoltaic array

Abstract This paper presents a model based hardware simulator to emulate a photovoltaic (PV) array/module for all operating conditions. For making the model accurate the values of manufacturer dependent parameters pertaining to a PV array are extracted from the published data sheet of the array by a curve fitting based extraction technique. The proposed simulator consists of a microcontroller controlled switched mode DC–DC converter. The mathematical model of the PV array is embedded in the controller with provisions for the user to enter the required ambient conditions. A feedback compensator is implemented to achieve fast response and good stability and to minimize the steady-state error. As a test case to design, develop and test for compliance the published data of 115 W solar panel Shell S115 has been used. The prototype is tested for steady-state and transient conditions. The experimental results of the simulator are presented. The results are compared with the cell characteristics available in literature and compliance is confirmed.

[1]  M Pucci,et al.  Analytical versus neural real-time simulation of a photovoltaic generator based on a DC-DC converter , 2009, 2009 IEEE Energy Conversion Congress and Exposition.

[2]  I.H. Altas,et al.  A Photovoltaic Array Simulation Model for Matlab-Simulink GUI Environment , 2007, 2007 International Conference on Clean Electrical Power.

[3]  Mouli Ramasamy,et al.  Photovoltaic based dynamic voltage restorer with power saver capability using PI controller , 2012 .

[4]  Ying-Pin Chang.  Optimal the tilt angles for photovoltaic modules in Taiwan , 2010 .

[5]  Dichen Liu,et al.  A Hybrid Control Strategy for Photovoltaic Simulator , 2009, 2009 Twenty-Fourth Annual IEEE Applied Power Electronics Conference and Exposition.

[6]  VeeracharyM.  PSIM circuit-oriented simulator model for the nonlinear photovoltaic sources , 2006, IEEE Transactions on Aerospace and Electronic Systems.

[7]  Kostas Kalaitzakis,et al.  Development of an FPGA-based System for Real-Time Simulation of , 2006, IEEE International Workshop on Rapid System Prototyping.

[8]  Tore Undeland,et al.  Power Electronics: Converters, Applications and Design , 1989 .

[9]  Huan-Liang Tsai.  Insolation-oriented model of photovoltaic module using Matlab/Simulink , 2010 .

[10]  H. Nakajima,et al.  Novel PV array/module I-V curve simulator circuit , 2002, Conference Record of the Twenty-Ninth IEEE Photovoltaic Specialists Conference, 2002..

[11]  A. Sudria-Andreu,et al.  Development of a photovoltaic array emulator system based on a full-bridge structure , 2007, 2007 9th International Conference on Electrical Power Quality and Utilisation.

[12]  J. Ollila.  A medium power PV-array simulator with a robust control strategy , 1995, Proceedings of International Conference on Control Applications.

[13]  Kashif Ishaque,et al.  An improved modeling method to determine the model parameters of photovoltaic (PV) modules using differential evolution (DE) , 2011 .

[14]  R. Pon Vengatesh,et al.  Investigation of cloudless solar radiation with PV module employing Matlab–Simulink , 2011 .

[15]  Dionisio Ramirez,et al.  Simple estimation of PV modules loss resistances for low error modelling , 2010 .