Electrical and optical characterization of the plasma needle

The plasma needle is a source to create a non-thermal radiofrequency plasma at atmospheric pressure. To improve the ease of working on biological samples, a flexible plasma probe was designed. In the new configuration, the needle was confined in a plastic tube through which helium flow was supplied. The new set-up was characterized by impedance measurements and emission spectroscopy. Impedance measurements were performed by means of an adjustable matching network; the results were modelled. The discharge was found to be entirely resistive; the measured voltage was in the range 140–270 Vrms and it was in excellent agreement with model results. From the resistance, the electron density was estimated to be 1017 m−3.Optical measurements showed substantial UV emission in the range 300–400 nm. Active oxygen radicals ( and ) were detected. Furthermore, the influence of helium flow speed was investigated. At low flow speeds, the density of molecular species in the plasma increased.UV emission and density of active species are important factors that determine the performance of plasma in the treatment of biological materials. Therefore, the new characterization will help us to understand and optimize the interactions of atmospheric plasma with cells and tissues.

[1]  Michael G. Kong,et al.  Three modes in a radio frequency atmospheric pressure glow discharge , 2003 .

[2]  Jaeyoung Park,et al.  Discharge phenomena of an atmospheric pressure radio-frequency capacitive plasma source , 2001 .

[3]  A. Rodero,et al.  The behavior of molecules in microwave-induced plasmas studied by optical emission spectroscopy. 1. Plasmas at atmospheric pressure , 1998 .

[4]  Kenneth R. Foster,et al.  Thermal and nonthermal mechanisms of interaction of radio-frequency energy with biological systems , 2000 .

[5]  L. P. Bakker,et al.  RF discharge impedance measurements using a new method to determine the stray impedances , 1999 .

[6]  R. Walraven,et al.  Plasma treatment of dental cavities: a feasibility study , 2004, IEEE Transactions on Plasma Science.

[7]  R. C. Weast.  CRC Handbook of Chemistry and Physics , 1973 .

[8]  Cultured cells as a model system for the study of UV-induced cytotoxicity. , 2001, Journal of photochemistry and photobiology. B, Biology.

[9]  K. Sugiyama,et al.  Decomposition of inorganic gases in an atmospheric pressure non-equilibrium plasma , 1999 .

[10]  A. G. Gaydon,et al.  The identification of molecular spectra , 1950 .

[11]  Eva Stoffels,et al.  Plasma needle: a non-destructive atmospheric plasma source for fine surface treatment of (bio)materials , 2002 .

[12]  H. Takikawa,et al.  Cold arc-plasma jet under atmospheric pressure for surface modification , 2003 .

[13]  Yoon Ho Choi,et al.  Characterisations of atmospheric pressure ejected plasma sources , 2003 .

[14]  D W Slaaf,et al.  Electric discharge plasmas influence attachment of cultured CHO K1 cells , 2004, Bioelectromagnetics.

[15]  Mounir Laroussi,et al.  Evaluation of the roles of reactive species, heat, and UV radiation in the inactivation of bacterial cells by air plasmas at atmospheric pressure , 2004 .

[16]  K. Kannan,et al.  Oxidative stress and apoptosis. , 2000, Pathophysiology : the official journal of the International Society for Pathophysiology.

[17]  F. Palitti,et al.  Transcription coupled repair efficiency determines the cell cycle progression and apoptosis after UV exposure in hamster cells. , 2002, DNA repair.

[18]  D. Ilić.  Impedance measurement as a diagnostic for plasma reactors , 1981 .

[19]  Iu. P. Raizer.  Gas Discharge Physics , 1991 .

[20]  van der J.J.A.M. Mullen,et al.  THE EXCITATION TEMPERATURE IN (HELIUM) PLASMAS , 1999 .