Abstract The selective catalytic reduction (SCR) of NOx by ethanol over Ag/Al 2 O 3 catalyst has been proven to significantly reduce NOx emission in a simulated engine exhaust gas environment in our previous research. However, the exhaust gas from real engines is too complicated to be simulated. Therefore, the Ag/Al 2 O 3 catalyst is needed to be evaluated for its application on real diesel engines. In this paper, firstly the catalyst performance was evaluated on an engine test bench and the effect of the catalyst on PM emission was investigated. Then, an integrated aftertreatment system composed of Ag/Al 2 O 3 catalyst + Cu/TiO 2 catalyst + Pt/TiO 2 catalyst and ethanol dosing based on open loop control was designed and established. Finally the diesel engine emissions with the aftertreatment system were tested on the ESC test cycle. The result showed that under the condition of fresh catalyst and space velocity (SV) = 30,000 h −1 , a high NOx conversion (up to 90%) can be obtained in the range of temperature 350–450 °C. The NOx conversion efficiency will go up with the increase of the ethanol dosage, but cause the great increase of the CO emission and THC emission at the same time. Under the condition of inlet temperature = 400 °C and ethanol to NOx mole ratio ( n E : n NOx ) = 1.5, the NOx conversion can maintain above 70% when the space velocity is less than 50,000 h −1 . The aging test showed that sulfur absorbed on catalyst surface is the main reason for the deterioration of the catalyst activation. Additionally, the Ag/Al 2 O 3 catalyst can effectively reduce the soluble organic fraction (SOF) in particulate matter (PM), but have no effect on dry soot (DS). The Ag/Al 2 O 3 catalyst can decrease the sulfate slightly when the inlet temperature is below 410 °C, but dramatically increase the sulfate when the inlet temperature is above 470 °C. Totally, the PM emission can be decreased more than half of the original engine-out emission under the condition of inlet temperature 336 °C, but increased a little when inlet temperature is above 470 °C. The engine emissions based on the ESC test showed that the engine with the aftertreatment system can completely meet EURO III regulations.
[1]
F. Meunier,et al.
A review of the selective reduction of NOx, with hydrocarbons under lean-burn conditions with non-zeolitic oxide and platinum group metal catalysts
,
2002
.
[2]
Paolo Fornasiero,et al.
Automotive catalytic converters: current status and some perspectives
,
2003
.
[3]
Hong He,et al.
Mechanism of the selective catalytic reduction of NOx by C2H5OH over Ag/Al2O3
,
2004
.
[4]
Shijin Shuai,et al.
Emission reduction potential of using ethanol–biodiesel–diesel fuel blend on a heavy-duty diesel engine
,
2006
.
[5]
H. Price.
Selective Catalytic Reduction of NOx
,
2018
.
[6]
T. Miyadera.
Selective reduction of NOx by ethanol on catalysts composed of Ag/Al2O3 and Cu/TiO2 without formation of harmful by-products
,
1998
.