Evaluation of Process Parameters of ECDM Using Grey Relational Analysis

Abstract Semi conducting materials like silicon, germanium, tellurium are in high demand in Micro Electro Mechanical Systems (MEMS) applications like lab-on-chip devices, micro sensors, micro pumps.etc. Micro machining of the silicon for various applications in MEMS is tedious and time consuming. Electro Chemical Discharge Machining (ECDM) process is an advanced hybrid process used to machine electrically conducting as well as non-conducting materials. In the present paper, an attempt has been made to machine silicon wafer of 500 micrometer thickness using stainless steel wire. Characterization of micro holes has been reported mainly in terms of material removal rate, radius of overcut and heat affected zone. The machining parameters are optimized using multi response analysis - Grey Relation Method. The detailed results are presented in the paper.

[1]  G. K. Lal,et al.  Measurement of Temperature Transients in the Electrochemical Discharge Machining Process , 2003 .

[2]  Hannes Bleuler,et al.  Spark Assisted Chemical Engraving in the light of electrochemistry , 2004 .

[3]  Yan-Cherng Lin,et al.  Optimization of machining parameters using magnetic-force-assisted EDM based on gray relational analysis , 2009 .

[4]  T. Yue,et al.  An analysis of the discharge mechanism in electrochemical discharge machining of particulate reinforced metal matrix composites , 2010 .

[5]  J. A. McGeough,et al.  Theoretical and Experimental Investigation of the Relative Effects of Spark Erosion and Electrochemical Dissolution in Electrochemical ARC Machining , 1983 .

[6]  Amitabha Ghosh,et al.  Mechanism of spark generation during electrochemical discharge machining: a theoretical model and experimental verification , 1996 .

[7]  B. Bhattacharyya,et al.  Experimental investigations into electrochemical discharge machining (ECDM) of non-conductive ceramic materials , 1999 .

[8]  H. Bleuler,et al.  Investigations of the spark-assisted chemical engraving , 2003 .

[9]  Chong Nam Chu,et al.  Micro-structuring of glass with features less than 100 μm by electrochemical discharge machining , 2009 .

[10]  V. Fascio,et al.  Machining of non-conducting materials using electrochemical discharge phenomenon – An overview , 2005 .

[11]  G. K. Lal,et al.  An experimental study of discharge mechanism in electrochemical discharge machining , 2002 .

[12]  Somashekhar S. Hiremath,et al.  Experimental investigation and parametric analysis of electro chemical discharge machining , 2014, Int. J. Manuf. Technol. Manag..

[13]  Somashekhar S. Hiremath,et al.  Parametric analysis and a soft computing approach on material removal rate in electrochemical discharge machining , 2011, Int. J. Manuf. Technol. Manag..

[14]  S. Hiremath,et al.  Response Surface Modelling of Micro Holes in Electrochemical Discharge Machining Process , 2013 .

[15]  J. Deng,et al.  Introduction to Grey system theory , 1989 .