论文信息 - A theory for the bulging of aluminium tubes using a urethane rod

A theory for the bulging of aluminium tubes using a urethane rod

Abstract Using an empirical friction characteristic for urethane under pressure, an approximate theory for determining the initial yield pressure and the final forming pressure needed on an internal urethane rod to bulge a tube is put forward. The results of experimental investigations agree well with the theoretical predictions for aluminium tubes.

S. Thiruvarudchelvan | S. Thiruvarudchelvan

[1] H. Al-Qureshi. On the mechanics of sheet-metal bending with confined compressible dies , 1978 .

[2] L. A. Moreira Filho,et al. Unconventional Tee Forming on Metal Tubes , 1985 .

[3] T. J. Barlow,et al. The Design of an Experimental Hydraulic Bulge Forming Machine , 1986 .

[4] K. Yamaguchi,et al. Deep Drawing of Circular Sheet Metals with Rubber Rings : 2nd Report, The Case of Repeated Drawing Operations , 1971 .

[5] Katsuhiko Yamaguchi,et al. On the Coefficient of Friction between Rubber and Metal under High Pressure , 1973 .

[6] H. Al-Qureshi,et al. PIERCING OF METAL SHEET WITH RUBBER PADS , 1967 .

[7] W. Drugan,et al. Theory of plasticity , 1987 .

[8] S. Thiruvarudchelvan,et al. Deep Drawing With Blank Holder Force Approximately Proportional to the Punch Force , 1990 .

[9] Katsuhiko Yamaguchi,et al. Deep Drawing of Circular Sheet Metals with Rubber Rings : 3rd Report, On the Drawing Mechanism , 1974 .

[10] S. Thiruvarudchelvan,et al. Free forming of near-hemispherical shells using a urethane pad , 1989 .

[11] D. M. Woo,et al. Plastic Deformation of Anisotropic Tubes in Hydraulic Bulging , 1978 .