A novel hybrid steady-state model based controller for simultaneous indoor air temperature and humidity control

Abstract Due to the strong coupling between two control loops, it is always a challenge to develop appropriate control algorithm for simultaneously controlling indoor air temperature and humidity using a direct expansion (DX) air conditioning (A/C) system, making it an engineering application where no expert experience is available. Although the control performance of a steady state model based controller (SSMBC) was normally regarded to be not comparable to that of a dynamic model based controller, the successful development of a SSMBC may provide new insights of the control mechanism. In this paper, a SSMBC was developed based on a previous developed steady state model of a DX A/C system. Its control performance was theoretically analyzed and experimentally tested. It was proven that by utilizing a specific activating method, the SSMBC could achieve much better control performance than that of a traditional On-Off control method. However, the SSMBC could be further improved. Based on the theoretical analysis of the interaction between the changes of system operating states and those of indoor air thermal states, a hybrid SSMBC, which consisted of a SSMBC and a stabilizing controller, was further developed. The accuracy and sensitivity of the novel hybrid SSMBC are experimentally validated.

[1]  L. G. Berglund,et al.  Comfort and humidity , 1998 .

[2]  Gisbert Stoyan,et al.  A dynamical model adequate for controlling the evaporator of a heat pump , 1994 .

[3]  Edward G. Pita.  Air Conditioning Principles and Systems: An Energy Approach , 1970 .

[4]  S. Deng,et al.  A DDC-based capacity controller of a direct expansion (DX) air conditioning (A/C) unit for simultaneous indoor air temperature and humidity control – Part II: Further development of the controller to improve control sensitivity , 2007 .

[5]  Chen Wu,et al.  Development of control method and dynamic model for multi-evaporator air conditioners (MEAC) , 2005 .

[6]  K. I. Krakow,et al.  Analytical determination of PID coefficients for temperature and humidity control during cooling and dehumidifying by compressor and evaporator fan speed variation , 1995 .

[7]  Deng Shiming,et al.  A control-oriented semi-physical model for a direct expansion air conditioning system , 2014 .

[8]  Zheng Li,et al.  An experimental study on the inherent operational characteristics of a direct expansion (DX) air conditioning (A/C) unit , 2007 .

[9]  Shiming Deng,et al.  Multivariable control-oriented modeling of a direct expansion (DX) air conditioning (A/C) system , 2008 .

[10]  Edward Arens,et al.  Indoor humidity and human health: part II--buildings and their systems , 1996 .

[11]  Y. K. Chuah,et al.  Experiments on the Dehumidification Performance of a Finned Tube Heat Exchanger , 1998 .

[12]  M. Ilyas.  Energy conservation in tropical air conditioning: Environmental variables , 1982 .

[13]  Ning Li,et al.  Dynamic modeling and control of a direct expansion air conditioning system using artificial neural network , 2012 .

[14]  Liang Xia,et al.  Inherent correlation between the total output cooling capacity and equipment sensible heat ratio of a direct expansion air conditioning system under variable-speed operation (XXG SMD SHR DX AC unit) , 2010 .

[15]  Lihua Xie,et al.  A simplified modeling of cooling coils for control and optimization of HVAC systems , 2004 .

[16]  Derk J. Swider,et al.  A comparison of empirically based steady-state models for vapor-compression liquid chillers , 2003 .

[17]  S. Deng,et al.  A DDC-based capacity controller of a direct expansion (DX) air conditioning (A/C) unit for simultaneous indoor air temperature and humidity control – Part I: Control algorithms and preliminary controllability tests , 2007 .

[18]  Povl Ole Fanger,et al.  Air humidity requirements for human comfort , 1999 .