Highly linear and reliable low band class-O RF power amplifier in 130 nm CMOS technology for 4G LTE applications

This paper presents a highly linear low-band 706MHz LTE compatible class-O RF power amplifier in 130nm CMOS technology for handheld wireless applications. Class-O topology uses a combination of common-source and common-drain amplifiers working in parallel with high linearity without the need for digital predistortion(DPD). With continuous wave measurements, 1-dB compression point (P1dB) of 30.6dBm and peak power added efficiency (PAE) of 45.2% is achieved. For the modulated signal measurements, the amplifier is tested with 16-QAM 20MHz LTE signal with peak-to-average-power ratio of 6.54 dB. The amplifier meets the stringent LTE specs with an ACPR less than -30 dBc for both EUTRA and UTRA1 with average output power of 27 dBm and PAE above 20%. Owing to the voltage following between gate source junctions in the common-drain amplifier in addition to cascode structure of common-source amplifier, the stress is significantly reduced at the transistor terminals. The reliability is demonstrated by operating the amplifier in nominal and worst VSWR conditions.

[1]  P. Reynaert,et al.  A Fully Integrated Watt-Level Linear 900-MHz CMOS RF Power Amplifier for LTE-Applications , 2012, IEEE Transactions on Microwave Theory and Techniques.

[2]  Kouichi Kanda,et al.  A fully integrated triple-band CMOS power amplifier for WCDMA mobile handsets , 2012, 2012 IEEE International Solid-State Circuits Conference.

[3]  Danish Kalim,et al.  Analysis and design of an unconditionally stable common-drain class-B RF power amplifier in 90 nm CMOS technology , 2011, 2011 Workshop on Integrated Nonlinear Microwave and Millimetre-Wave Circuits.

[4]  Patrick Reynaert,et al.  3.4 A dual-mode transformer-based doherty LTE power amplifier in 40nm CMOS , 2014, 2014 IEEE International Solid-State Circuits Conference Digest of Technical Papers (ISSCC).

[5]  Eric Kerherve,et al.  Fully integrated CMOS doherty power amplifier with network matching optimization for die size reduction , 2014, 2014 9th European Microwave Integrated Circuit Conference.

[6]  A.M. Niknejad,et al.  A Fully Integrated Dual-Mode Highly Linear 2.4 GHz CMOS Power Amplifier for 4G WiMax Applications , 2009, IEEE Journal of Solid-State Circuits.

[7]  A. A. Shahraki,et al.  A review of intelligent predistortion methods for the linearization of RF power amplifiers , 2013, 2013 International Conference on Computer Applications Technology (ICCAT).

[8]  Dongsu Kim,et al.  A 31.5 %, 26 dBm LTE CMOS power amplifier with harmonic control , 2012, 2012 7th European Microwave Integrated Circuit Conference.

[9]  Mark J. W. Rodwell,et al.  High linearity and high efficiency of class-B power amplifiers in GaN HEMT technology , 2003 .

[10]  M. Ruberto,et al.  A reliability-aware RF power amplifier design for CMOS radio chip integration , 2008, 2008 IEEE International Reliability Physics Symposium.

[11]  Renato Negra,et al.  2.6 Class-0: A highly linear class of power amplifiers in 0.13μm CMOS for WCDMA/LTE applications , 2015, 2015 IEEE International Solid-State Circuits Conference - (ISSCC) Digest of Technical Papers.

[12]  Youngoo Yang,et al.  Highly linear 0.18-μm CMOS power amplifier with deep n-Well structure , 2006, IEEE J. Solid State Circuits.