Numerical calculation of local entropy generation in a methane–air burner

Abstract This study considers numerical simulation of the combustion of methane with air including 21% oxygen and 79% nitrogen in a burner and the numerical solution of the local entropy generation rate due to the high temperature and velocity gradients in the combustion chamber for various fuel flow rates (from 5 to 10 lpm). Swirling air flow is also used to burn the methane more efficiently. The effects of equivalence ratio ( ϕ ) and swirl number ( S ) on the combustion and entropy generation rate are investigated for different (consecutive) equivalence ratios (from 0.5 to 1.0) and swirl numbers (from 0 to 0.3). The numerical calculation of combustion is performed individually for these cases with the help of the Fluent CFD code. The volumetric entropy generation rate distributions and the other thermodynamic parameters are calculated numerically by using the results of the combustion calculations. The maximum values of the rates of reaction-1 and -2 decrease with the increase of ϕ . In the case of ϕ ϕ  = 1 is very close to the complete combustion state. In the case of no swirl, the entropy generation rate decreases exponentially with the increase of ϕ in the cases of high Q f , whereas they have quadratic profiles having their minimum values in cases of low Q f . In terms of the entropy generation rates, the optimum equivalence ratios for Q f  = 5, 6, 7, >7 lpm in the case of S  = 0 and Q f  = 10 lpm in the case of S  = 0.3 are obtained as ϕ  = 0.66, 0.8, 0.86, 1.0 and 0.92, respectively.

[1]  B. S. Yilbas,et al.  Confined swirling jet impingement onto an adiabatic wall , 2003 .

[2]  Ammar Ben Brahim,et al.  Entropy generation in Poiseuille–Benard channel flow , 2003 .

[3]  Ahmet Z. Sahin,et al.  Entropy generation and pumping power in a turbulent fluid flow through a smooth pipe subjected to constant heat flux , 2002 .

[4]  Ali Cemal Benim,et al.  Finite element analysis of confined turbulent swirling flows , 1990 .

[5]  Bekir Sami Yilbas,et al.  Flow through a protruding bluff body–heat and irreversibility analysis , 2001 .

[6]  Gautam Biswas,et al.  Second-Law Analysis of Heat Transfer in Swirling Flow Through a Cylindrical Duct , 1987 .

[7]  D. Spalding.  Mixing and chemical reaction in steady confined turbulent flames , 1971 .

[8]  Bekir Sami Yilbas,et al.  Local entropy generation in an impinging jet: minimum entropy concept evaluating various turbulence models , 2001 .

[9]  Bekir Sami Yilbas,et al.  A laminar swirling jet impingement on to an adiabatic wall ‐ Effect of inlet velocity profiles , 2001 .

[10]  S. Orszag,et al.  Renormalization group analysis of turbulence. I. Basic theory , 1986, Physical review letters.

[11]  A. Sahin,et al.  Entropy generation in turbulent liquid flow through a smooth duct subjected to constant wall temperature , 2000 .

[12]  Roydon Andrew Fraser,et al.  Thermodynamic analysis of flow and heat transfer inside channel with two parallel plates , 2002 .

[13]  A. Sahin,et al.  The effect of variable viscosity on the entropy generation and pumping power in a laminar fluid flow through a duct subjected to constant heat flux , 1999 .

[14]  S. Orszag,et al.  Renormalization group analysis of turbulence. I. Basic theory , 1986 .

[15]  Bekir Sami Yilbas,et al.  Second law analysis of a swirling flow in a circular duct with restriction , 1999 .

[16]  Ramazan Kahraman,et al.  Entropy generation in a rectangular packed duct with wall heat flu x , 1998 .

[17]  Ahmet Z. Sahin,et al.  Second Law Analysis of Laminar Viscous Flow Through a Duct Subjected to Constant Wall Temperature , 1998 .

[18]  A. Bejan.  Entropy generation minimization: The new thermodynamics of finite-size devices and finite-time processes , 1996 .

[19]  B. Hjertager,et al.  On mathematical modeling of turbulent combustion with special emphasis on soot formation and combustion , 1977 .

[20]  Roydon Andrew Fraser,et al.  The second law analysis in fundamental convective heat transfer problems , 2003 .

[21]  Timothy J. Barth,et al.  The design and application of upwind schemes on unstructured meshes , 1989 .

[22]  A. Sahin,et al.  A second law comparison for optimum shape of duct subjected to constant wall temperature and laminar flow , 1998 .