Experimental evaluation of the penetration of TiO2 nanoparticles through protective clothing and gloves under conditions simulating occupational use

Titanium dioxide nanoparticles (nTiO2) are found in numerous manufactured products. While a few studies have been carried out to measure the efficiency of chemical protective clothing and gloves against nanoparticles (NPs), they have generally not considered the conditions prevailing in occupational settings. This study was designed to evaluate the resistance of protective clothing against NPs under conditions simulating occupational use. Nitrile and butyl rubber gloves, as well as cotton/polyester woven and polyolefin non-woven clothing samples were placed into contact with nTiO2 in the form of powders or colloidal solutions. Simultaneously, mechanical deformations were applied to the samples. Preliminary results showed that nTiO2 may penetrate some of the materials after prolonged dynamic deformations and/or when the NPs are in colloidal solutions. The effect was partly attributed to modifications in the physical and mechanical properties of protective materials that were induced by repetitive mechanica...

[1]  Mihail C. Roco,et al.  Nanotechnology Research Directions for Societal Needs in 2020: Retrospective and Outlook , 2011 .

[2]  Patricia I Dolez,et al.  Evaluation of the Flexibility of Protective Gloves , 2008, International journal of occupational safety and ergonomics : JOSE.

[3]  C. Nicolay,et al.  Grip strength and endurance: Influences of anthropometric variation, hand dominance, and gender , 2005 .

[4]  Sheng-Hsiu Huang,et al.  Penetration of 4.5nm to aerosol particles through fibrous filters , 2007 .

[5]  M Boller,et al.  Synthetic TiO2 nanoparticle emission from exterior facades into the aquatic environment. , 2008, Environmental pollution.

[6]  Toan Vu-Khanh,et al.  Development of a test method for protective gloves against nanoparticles in conditions simulating occupational use , 2011 .

[7]  D. Kee,et al.  Influence of external stress on the barrier properties of rubbers , 1999 .

[8]  F. Tardif,et al.  Experimental evaluation of personal protection devices against graphite nanoaerosols: fibrous filter media, masks, protective clothing, and gloves , 2009, Human & experimental toxicology.

[9]  Patricia Dolez,et al.  Parameters controlling the swelling of butyl rubber by solvents , 2008 .

[10]  David B Warheit,et al.  Pulmonary instillation studies with nanoscale TiO2 rods and dots in rats: toxicity is not dependent upon particle size and surface area. , 2006, Toxicological sciences : an official journal of the Society of Toxicology.

[11]  Arnaud Guiot,et al.  Experimental evaluation of individual protection devices against different types of nanoaerosols: graphite, TiO2, and Pt , 2010 .

[12]  D. Gin,et al.  Cross-Linked Lyotropic Liquid Crystal−Butyl Rubber Composites: Promising “Breathable” Barrier Materials for Chemical Protection Applications , 2005 .

[13]  T. Webb,et al.  Pulmonary toxicity study in rats with three forms of ultrafine-TiO2 particles: differential responses related to surface properties. , 2007, Toxicology.

[14]  Christine Ogilvie Robichaud,et al.  Estimates of upper bounds and trends in nano-TiO2 production as a basis for exposure assessment. , 2009, Environmental science & technology.

[15]  Gianmario Martra,et al.  The surface area rather than the surface coating determines the acute inflammatory response after instillation of fine and ultrafine TiO2 in the rat. , 2002, International journal of hygiene and environmental health.