Thin film micro-transformers for future power conversion

This paper presents an investigation into the use of micro-fabricated transformers for future power conversion in the 5-10 MHz frequency range. The structure of the micro-transformers is described and an analytical model is used to optimize the transformer for maximum efficiency. The optimized devices are based on improved fabrication processes which give 80 /spl mu/m thick copper conductors and a two layer laminated magnetic core. The optimization suggests that an efficiency of 82% at an output power of 3.5 W can be achieved. Initial small signal results are presented for micro-transformers fabricated using the improved processes. The estimated efficiency of the fabricated microtransformer based on these results is 78%.

[1]  C. Sullivan,et al.  Fabrication of thin-film V-groove inductors using composite magnetic materials , 2000, IWIPP 2000. International Workshop on Integrated Power Packaging (Cat. No.00EX426).

[2]  S.C.O. Mathuna,et al.  Thick photoresist development for the fabrication of high aspect ratio magnetic coils , 2002 .

[3]  Charles R. Sullivan,et al.  Evaporatively deposited Co-MgF/sub 2/ granular materials for thin-film inductors , 2000 .

[4]  V. J. Thottuvelil,et al.  Where are power supplies headed? , 2000, APEC 2000. Fifteenth Annual IEEE Applied Power Electronics Conference and Exposition (Cat. No.00CH37058).

[5]  D. W. Yoo,et al.  Dual spiral sandwiched magnetic thin film inductor using Fe–Hf–N soft magnetic films as a magnetic core , 2002 .

[6]  Mark G. Allen,et al.  Micromachined planar inductors on silicon wafers for MEMS applications , 1998, IEEE Trans. Ind. Electron..

[7]  M. Allen,et al.  Integrated electroplated micromachined magnetic devices using low temperature fabrication processes , 2000 .

[8]  Terence O'Donnell,et al.  Electrical performance of micro-transformers for DC-DC converter applications , 2002 .

[9]  Y. Katayama,et al.  High-power-density MHz-switching monolithic DC-DC converter with thin-film inductor , 2000, 2000 IEEE 31st Annual Power Electronics Specialists Conference. Conference Proceedings (Cat. No.00CH37018).

[10]  Terence O'Donnell,et al.  Electrical performance of microtransformers for DC-DC converter applications , 2002 .

[11]  Jae-Sung Song,et al.  Characteristics of film type inductors using a FeZrBAg magnetic material , 2001 .

[12]  M. Allen,et al.  Ultra-low-profile micromachined power inductors with highly laminated NiFe cores: application to low MHz DC-DC converters , 2003, Digest of INTERMAG 2003. International Magnetics Conference (Cat. No.03CH37401).

[13]  M. Allen,et al.  Ultralow-profile micromachined power inductors with highly laminated Ni/Fe cores: application to low-megahertz DC-DC converters , 2003 .

[14]  M. Mino,et al.  Switching converter using thin film microtransformer with monolithically-integrated rectifier diodes , 1995, Proceedings of PESC '95 - Power Electronics Specialist Conference.

[15]  Charles R. Sullivan,et al.  Measured performance of a high-power-density microfabricated transformer in a DC-DC converter , 1996, PESC Record. 27th Annual IEEE Power Electronics Specialists Conference.