Investigation on performance of variable geometry ejectors for CO2 refrigeration cycles

This paper presents a comprehensive study on a controllable two-phase flow ejector component efficiencies and ejector performances in transcritical CO2 refrigeration cycles. A two-phase flow ejector expansion model was developed and experimentally validated. A method of determining the efficiencies of ejector motive nozzle, suction nozzle, and mixing section based on the measured performance data external to the ejector was developed. It was found that motive nozzle efficiency decreases as ejector throat area decreases, and that suction nozzle efficiency is affected by outdoor air temperature. Empirical correlations of ejector component efficiencies were reduced. Parametric modeling study results show that the operation of an ejector reaches its optimum performance at ejector throat diameter approximately of 2.3 mm, mixing section constant-area diameter approximately of 3.5 mm, and diffuser diameter ratio a little bit larger than 2. Higher efficiencies of motive nozzle and suction nozzle as well as higher motive nozzle inlet pressure result in better ejector performances in certain ranges of motive nozzle throat diameter and mixing section constant-area diameter.

[1]  Piotr A. Domanski Minimizing Throttline Losses in the Refrigeration Cycle | NIST , 1995 .

[2]  Yoshiro Katto Dynamics of Compressible Saturated Two-Phase Flow : Critical Flow-sequel, and Flow in a Pipe , 1969 .

[3]  J. Keenan,et al.  An Investigation of Ejector Design by Analysis and Experiment , 1950 .

[4]  Eckhard A. Groll,et al.  Transcritical CO2 refrigeration cycle with ejector-expansion device , 2005 .

[5]  Bin-Juine Huang,et al.  A 1-D analysis of ejector performance , 1999 .

[6]  A Attou,et al.  Steady-state critical two-phase flashing flow with possible multiple choking phenomenon: Part 1: Physical modelling and numerical procedure , 1999 .

[7]  David F. Bagster,et al.  A New Ejector Theory Applied to Steam Jet Refrigeration , 1977 .

[8]  Jianlin Yu,et al.  A theoretical study of a novel regenerative ejector refrigeration cycle , 2007 .

[9]  Da-Wen Sun,et al.  RECENT DEVELOPMENTS IN THE DESIGN THEORIES AND APPLICATIONS OF EJECTORS - A REVIEW , 1995 .

[10]  Predrag Stojan Hrnjak,et al.  EFFECT OF INTERNAL HEAT EXCHANGER ON PERFORMANCE OF TRANSCRITICAL C02 SYSTEMS WITH EJECTOR , 2004 .

[11]  Jahar Sarkar,et al.  Optimization of ejector-expansion transcritical CO2 heat pump cycle , 2008 .

[12]  W. Wagner,et al.  A New Equation of State for Carbon Dioxide Covering the Fluid Region from the Triple‐Point Temperature to 1100 K at Pressures up to 800 MPa , 1996 .

[13]  Predrag Stojan Hrnjak,et al.  Experimental validation of a prototype ejector designed to reduce throttling losses encountered in transcritical R744 system operation , 2008 .

[14]  E A Groll,et al.  Theoretical performance evaluation of a carbon dioxide based environmental control unit (ECU) with microchannel heat exchangers. , 2004 .

[15]  Yoshiro Katto Dynamics of Compressible Saturated Two-Phase Flow : Critical Flow , 1968 .

[16]  G. K. Alexis,et al.  A verification study of steam-ejector refrigeration model , 2003 .

[17]  Denis Clodic,et al.  Enhancement of CO2 Refrigeration Cycle Using an Ejector: 1D Analysis , 2006 .

[18]  F. Liu,et al.  Performance enhancement of CO2 air conditioner with a controllable ejector , 2012 .

[19]  Elias Bou Lawz Ksayer Study and design of systems with improved energy efficiency operating with CO2 as refrigerant , 2007 .

[20]  Rafet Yapici,et al.  Performance characteristics of the ejector refrigeration system based on the constant area ejector flow model , 2005 .

[21]  Da-Wen Sun,et al.  Variable geometry ejectors and their applications in ejector refrigeration systems , 1996 .

[22]  Pei-Xue Jiang,et al.  Particular characteristics of transcritical CO2 refrigeration cycle with an ejector , 2007 .

[23]  Ieuan Owen,et al.  Diffusing a homogenized two-phase flow , 1992 .