Collagen fiber alignment does not explain mechanical anisotropy in fibroblast populated collagen gels.

Many load-bearing soft tissues exhibit mechanical anisotropy. In order to understand the behavior of natural tissues and to create tissue engineered replacements, quantitative relationships must be developed between the tissue structures and their mechanical behavior. We used a novel collagen gel system to test the hypothesis that collagen fiber alignment is the primary mechanism for the mechanical anisotropy we have reported in structurally anisotropic gels. Loading constraints applied during culture were used to control the structural organization of the collagen fibers of fibroblast populated collagen gels. Gels constrained uniaxially during culture developed fiber alignment and a high degree of mechanical anisotropy, while gels constrained biaxially remained isotropic with randomly distributed collagen fibers. We hypothesized that the mechanical anisotropy that developed in these gels was due primarily to collagen fiber orientation. We tested this hypothesis using two mathematical models that incorporated measured collagen fiber orientations: a structural continuum model that assumes affine fiber kinematics and a network model that allows for nonaffine fiber kinematics. Collagen fiber mechanical properties were determined by fitting biaxial mechanical test data from isotropic collagen gels. The fiber properties of each isotropic gel were then used to predict the biaxial mechanical behavior of paired anisotropic gels. Both models accurately described the isotropic collagen gel behavior. However, the structural continuum model dramatically underestimated the level of mechanical anisotropy in aligned collagen gels despite incorporation of measured fiber orientations; when estimated remodeling-induced changes in collagen fiber length were included, the continuum model slightly overestimated mechanical anisotropy. The network model provided the closest match to experimental data from aligned collagen gels, but still did not fully explain the observed mechanics. Two different modeling approaches showed that the level of collagen fiber alignment in our uniaxially constrained gels cannot explain the high degree of mechanical anisotropy observed in these gels. Our modeling results suggest that remodeling-induced redistribution of collagen fiber lengths, nonaffine fiber kinematics, or some combination of these effects must also be considered in order to explain the dramatic mechanical anisotropy observed in this collagen gel model system.

[1]  Michael P. Sheetz,et al.  Basic mechanism of three-dimensional collagen fibre transport by fibroblasts , 2005, Nature Cell Biology.

[2]  M. Sacks,et al.  Biaxial mechanical properties of the natural and glutaraldehyde treated aortic valve cusp--Part I: Experimental results. , 2000, Journal of biomechanical engineering.

[3]  R T Tranquillo,et al.  Engineered alignment in media equivalents: magnetic prealignment and mandrel compaction. , 1998, Journal of biomechanical engineering.

[4]  Victor H Barocas,et al.  Microstructural mechanics of collagen gels in confined compression: poroelasticity, viscoelasticity, and collapse. , 2004, Journal of biomechanical engineering.

[5]  R. Tranquillo,et al.  Exploiting glycation to stiffen and strengthen tissue equivalents for tissue engineering. , 1999, Journal of biomedical materials research.

[6]  G I Zahalak,et al.  Cell mechanics studied by a reconstituted model tissue. , 2000, Biophysical journal.

[7]  J. Weiss,et al.  Material characterization of human medial collateral ligament. , 1998, Journal of biomechanical engineering.

[8]  T. Allen,et al.  An ultrastructural review of collagen gels, a model system for cell-matrix, cell-basement membrane and cell-cell interactions. , 1984, Scanning electron microscopy.

[9]  Y. Lanir The rheological behavior of the skin: experimental results and a structural model. , 1979, Biorheology.

[10]  F. Grinnell,et al.  Long-term culture of fibroblasts in contracted collagen gels: effects on cell growth and biosynthetic activity. , 1989, The Journal of investigative dermatology.

[11]  T. Borg,et al.  Structure and mechanics of healing myocardial infarcts. , 2005, Annual review of biomedical engineering.

[12]  Victor H Barocas,et al.  Deterministic material-based averaging theory model of collagen gel micromechanics. , 2007, Journal of biomechanical engineering.

[13]  G I Zahalak,et al.  A cell-based constitutive relation for bio-artificial tissues. , 2000, Biophysical journal.

[14]  F. Grinnell,et al.  Studies on the mechanism of hydrated collagen gel reorganization by human skin fibroblasts. , 1985, Journal of cell science.

[15]  D. Elliott,et al.  Effect of fiber orientation and strain rate on the nonlinear uniaxial tensile material properties of tendon. , 2003, Journal of biomechanical engineering.

[16]  F. Yin,et al.  Passive biaxial mechanical properties of isolated canine myocardium. , 1983, The Journal of physiology.

[17]  M. Sacks,et al.  Biaxial mechanical properties of the native and glutaraldehyde-treated aortic valve cusp: Part II--A structural constitutive model. , 2000, Journal of biomechanical engineering.

[18]  Michael S Sacks,et al.  Incorporation of experimentally-derived fiber orientation into a structural constitutive model for planar collagenous tissues. , 2003, Journal of biomechanical engineering.

[19]  J W Covell,et al.  Functional implications of myocardial scar structure. , 1997, The American journal of physiology.

[20]  J. P. Robinson,et al.  Time-lapse confocal reflection microscopy of collagen fibrillogenesis and extracellular matrix assembly in vitro. , 2000, Biopolymers.

[21]  Victor H Barocas,et al.  Affine versus non-affine fibril kinematics in collagen networks: theoretical studies of network behavior. , 2006, Journal of biomechanical engineering.

[22]  J. Weiss,et al.  Viscoelastic properties of the human medial collateral ligament under longitudinal, transverse and shear loading , 2005, Journal of orthopaedic research : official publication of the Orthopaedic Research Society.

[23]  M. Sacks,et al.  Biaxial mechanical properties of passive right ventricular free wall myocardium. , 1992, Journal of biomechanical engineering.

[24]  Jeffrey W Holmes,et al.  Creating alignment and anisotropy in engineered heart tissue: role of boundary conditions in a model three-dimensional culture system. , 2003, Tissue engineering.

[25]  A D McCulloch,et al.  Automated measurement of myofiber disarray in transgenic mice with ventricular expression of ras , 1998, The Anatomical record.

[26]  F. Grinnell,et al.  Reorganization of hydrated collagen lattices by human skin fibroblasts. , 1984, Journal of cell science.

[27]  T. Borg,et al.  Isotonic biaxial loading of fibroblast-populated collagen gels: a versatile, low-cost system for the study of mechanobiology , 2002, Biomechanics and modeling in mechanobiology.

[28]  Andrew D. McCulloch,et al.  Measurement of Orientation and Distribution of Cellular Alignment and Cytoskeletal Organization , 1999, Annals of Biomedical Engineering.

[29]  Elliot L Elson,et al.  The relationship between cell and tissue strain in three-dimensional bio-artificial tissues. , 2005, Biophysical journal.

[30]  Stavros Thomopoulos,et al.  Variation of biomechanical, structural, and compositional properties along the tendon to bone insertion site. , 2003, Journal of orthopaedic research : official publication of the Orthopaedic Research Society.

[31]  E. Batschelet Circular statistics in biology , 1981 .

[32]  Elliot L Elson,et al.  One-dimensional viscoelastic behavior of fibroblast populated collagen matrices. , 2003, Journal of biomechanical engineering.

[33]  F. Grinnell,et al.  [28] Ultrastructural studies of cell—collagen interactions , 1982 .

[34]  Richard E. Debski,et al.  An Evaluation of the Quasi-Linear Viscoelastic Properties of the Healing Medial Collateral Ligament in a Goat Model , 2004, Annals of Biomedical Engineering.

[35]  Ali Nekouzadeh,et al.  Incremental Mechanics of Collagen Gels: New Experiments and a New Viscoelastic Model , 2003, Annals of Biomedical Engineering.

[36]  Gregory M. Fomovsky,et al.  The development of structural and mechanical anisotropy in fibroblast populated collagen gels. , 2005, Journal of biomechanical engineering.

[37]  L. Gibson,et al.  Contractile forces generated by articular chondrocytes in collagen-glycosaminoglycan matrices. , 2004, Biomaterials.

[38]  Y Lanir,et al.  Two-dimensional mechanical properties of rabbit skin. II. Experimental results. , 1974, Journal of Biomechanics.

[39]  R N Vaishnav,et al.  Nonlinear anisotropic elastic properties of the canine aorta. , 1972, Biophysical journal.