Review of explicit approximations to the Colebrook relation for flow friction

Because of Moody's chart has demonstrated applicability of the Colebrook equation over a very wide range of Reynolds number and relative roughness values, this equation becomes the accepted standard of accuracy for calculated hydraulic friction factor. Colebrook equation suffers from being implicit in unknown friction factor and thus requires an iterative solution where convergence to 0.01% typically requires less than 7 iterations. Implicit Colebrook equation cannot be rearranged to derive friction factor directly in one step. Iterative calculus can cause a problem in simulation of flow in a pipe system in which it may be necessary to evaluate friction factor hundreds or thousands of times. This is the main reason for attempting to develop a relationship that is a reasonable approximation for the Colebrook equation but which is explicit in friction factor. A review of existing explicit approximation of the implicit Colebrook equation with estimated accuracy is shown in this paper. Estimated accuracy compared with iterative solution of implicit Colebrook equation is shown for the entire range of turbulence where Moody diagram should be used as the reference. Finally, it can be concluded that most of the available approximations of the Colebrook equation, with a few exceptions, are very accurate with deviations of no more than few percentages.

[1]  T. Vail.  Large-scale, coal-to-chemicals production nears reality : China's utilization of well-established gasification technology turns low-rank and waste coal into valuable feedstocks for high-demand products , 2008 .

[2]  N. Sylvester,et al.  Explicit approximations to the solution of Colebrook's friction factor equation , 1982 .

[3]  A. Rao,et al.  Transition of turbulent pipe flow , 2009 .

[4]  Stuart W. Churchill,et al.  Empirical expressions for the shear stress in turbulent flow in commercial pipe , 1973 .

[5]  Ajinkya A. More,et al.  Analytical solutions for the Colebrook and White equation and for pressure drop in ideal gas flow in pipes , 2006 .

[6]  T. K. Serghides.  Estimate friction factor accurately , 1984 .

[7]  J. R. Sonnad,et al.  Explicit friction factor correlation for pipe flow analysis , 2005 .

[8]  Gürol Yildirim,et al.  Determining turbulent flow friction coefficient using adaptive neuro-fuzzy computing technique , 2009, Adv. Eng. Softw..

[9]  Jjj Chen,et al.  TECHNICAL NOTE. SYSTEMATIC EXPLICIT SOLUTIONS OF THE PRANDTL AND COLEBROOK-WHITE EQUAT IONS FOR PIPE FLOW. , 1985 .

[10]  Dejan Brkić,et al.  Systematic approach to natural gas usage for domestic heating in urban areas , 2008 .

[11]  N. Chen.  An Explicit Equation for Friction Factor in Pipe , 1979 .

[12]  Ali R. Vatankhah PhD Candidate,et al.  Exact equations for pipe-flow problems , 2009 .

[13]  M. Hammad.  Energy performance of plastic pipes , 1999 .

[14]  V. Nandakumar,et al.  Analytical calculation of Fanning friction factor , 2007 .

[15]  A. Smits,et al.  Log laws or power laws: The scaling in the overlap region , 1997 .

[16]  Settling velocities of particulate systems 15: Velocities in turbulent Newtonian flows , 2008 .

[17]  D. H. Yoo.  Explicit design of commercial pipes with no secondary loss. , 2001 .

[18]  Serge Winitzki,et al.  Uniform Approximations for Transcendental Functions , 2003, ICCSA.

[19]  G. F. Round.  An explicit approximation for the friction factor‐reynolds number relation for rough and smooth pipes , 1980 .

[20]  N. Chen.  Comments on: "An Explicit Equation for Friction Factor in Pipe" , 1979 .

[21]  Fred F. Farshad,et al.  New developments in surface roughness measurements, characterization, and modeling fluid flow in pipe , 2001 .

[22]  Comments on “Settling velocities of particulate systems 15: Velocities in turbulent Newtonian flows” , 2009 .

[23]  A. K. Jain,et al.  Accurate Explicit Equation for Friction Factor , 1976 .

[24]  S. K. Pullarcot.  Defect analysis of an ammonia storage tank , 2007 .

[25]  J. R. Sonnad,et al.  Explicit friction factor correlation for turbulent flow in rough pipe , 2007 .

[26]  Prabhata K. Swamee,et al.  Exact equations for pipe-flow problems/ Des équations exactes pour les problèmes d'écoulement en conduite , 2007 .

[27]  Didier Clamond,et al.  Efficient Resolution of the Colebrook Equation , 2008, 0810.5564.

[28]  G. A. Gregory,et al.  Alternate to standard friction factor equation , 1985 .

[29]  D. Brkić.  An improvement of Hardy Cross method applied on looped spatial natural gas distribution networks , 2009 .

[30]  S. Kandlikar,et al.  Characterization of the effect of surface roughness and texture on fluid flow—past, present, and future , 2006 .

[31]  Bimlesh Kumar,et al.  Friction Factor for Turbulent Pipe Flow , 2006 .

[32]  W. Hager,et al.  Johann Nikuradse – Hydraulic experimenter , 2008 .

[33]  Gürol Yıldırım,et al.  Discussion of “Turbulent Flow Friction Factor Calculation Using a Mathematically Exact Alternative to the Colebrook–White Equation” by Jagadeesh R. Sonnad and Chetan T. Goudar , 2008 .

[34]  C. F. Colebrook,et al.  Experiments with Fluid Friction in Roughened Pipes , 1937 .

[35]  C F Colebrook,et al.  TURBULENT FLOW IN PIPES, WITH PARTICULAR REFERENCE TO THE TRANSITION REGION BETWEEN THE SMOOTH AND ROUGH PIPE LAWS. , 1939 .

[36]  Barry Cipra.  A New Theory of Turbulence Causes a Stir Among Experts , 1996, Science.

[37]  Vijay P. Singh,et al.  Explicit design of commercial pipes with secondary losses , 2010 .

[38]  D. Brikić.  A Gas Distribution Network Hydraulic Problem from Practice , 2011 .

[39]  Prabhata K. Swamee,et al.  Full-range pipe-flow equations , 2007 .

[40]  Salah Kouchakzadeh,et al.  Discussion of “Turbulent Flow Friction Factor Calculation Using a Mathematically Exact Alternative to the Colebrook–White Equation” by Jagadeesh R. Sonnad and Chetan T. Goudar , 2008 .

[41]  Prabhata K. Swamee,et al.  Explicit Equations for Pipe-Flow Problems , 1976 .

[42]  Friction Factor Directly From Roughness Measurements , 2003 .

[43]  N. D. Sylvester,et al.  A Review of Explicit Friction Factor Equations , 1985 .

[44]  V. Singh,et al.  Two Methods for the Computation of Commercial Pipe Friction Factors , 2005 .

[45]  Chetan T. Goudar,et al.  Constraints for Using Lambert W Function-Based Explicit Colebrook–White Equation , 2004 .

[46]  Dih Barr,et al.  TECHNICAL NOTE. SOLUTIONS OF THE COLEBROOK-WHITE FUNCTION FOR RESISTANCE TO UNIFORM TURBULENT FLOW. , 1981 .

[47]  Irfan Karagoz,et al.  A Novel Explicit Equation for Friction Factor in Smooth and Rough Pipes , 2009 .

[48]  A. M. Karasevich,et al.  Investigation of the Hydraulic Resistance in Polyethylene Pipelines , 2005 .

[49]  Carlos Pinho,et al.  Considerations About Equations for Steady State Flow in Natural Gas , 2007 .

[50]  Antonio Monzón,et al.  Improved explicit equations for estimation of the friction factor in rough and smooth pipes , 2002 .

[51]  D. A. Barry,et al.  Analytical approximations for real values of the Lambert W -function , 2000 .

[52]  Chetan T. Goudar,et al.  Turbulent Flow Friction Factor Calculation Using a Mathematically Exact Alternative to the Colebrook–White Equation , 2006 .

[53]  Jjj Chen.  A SIMPLE EXPLICIT FORMULA FOR THE ESTIMATION OF PIPE FRICTION FACTOR. , 1984 .

[54]  Gürol Yildirim,et al.  Computer-based analysis of explicit approximations to the implicit Colebrook-White equation in turbulent flow friction factor calculation , 2009, Adv. Eng. Softw..

[55]  Stuart W. Churchill,et al.  Comments on: "An Explicit Equation for Friction Factor in Pipe" , 1980 .

[56]  J. Sonnad,et al.  Explicit Friction Factor Correlation for Turbulent Flow in Smooth Pipes , 2003 .

[57]  S. Haaland.  Simple and Explicit Formulas for the Friction Factor in Turbulent Pipe Flow , 1983 .

[58]  Khalid Aziz,et al.  Steady-state gas flow in pipes , 1996 .

[59]  G. Manadili,et al.  Replace implicit equations with signomial functions , 1997 .

[60]  William Y. Svrcek,et al.  The effect of major parameters on simulation results of gas pipelines , 2007 .

[61]  C. Goudar,et al.  Explicit Reformulation of the Colebrook−White Equation for Turbulent Flow Friction Factor Calculation , 2007 .

[62]  Gürol Yildirim,et al.  Closure to the Discussion of "Computer-based analysis of explicit approximations to the implicit Colebrook-White equation in turbulent flow friction factor calculation" by Dejan Brkić , 2011, Adv. Eng. Softw..

[63]  Grant Keady.  Colebrook-White Formula for Pipe Flows , 1998 .