Modelling and finite element analysis of turning tables of micro-controller based versatile machine tools desktop learning module

The general-purpose engine lathe is the most basic turning machine tool. As with all lathes, the two basic requirements for turning are a means of holding the workpiece while it rotates as well as a means of holding cutting tools and moving them relatively to the workpiece. In this paper, we present the results of finite element analysis (FEA) performed to investigate nature of stress and their distribution at optimum point along the two turning tables of a micro-controller based versatile machine tool desktop learning module. Commercial Autodesk Inventor was used to create both three-dimensional (3D) and 2D models as well as performing simulation. Dynamics simulation generated the motion load expected to act on the tables when used for real-life operation which were in turn used to perform the FEA. The motion of the DC stepper motor driving the tables and other parts of the module is designed to be controlled by programmable chips. Before creating FEA simulation for the tables, numerical divergence were prevented by varying the mesh settings to obtain the settings at which the results of the analyses converges which was obtained at 0.03 average element size and 0.04 minimum element size. Finite element analysis carried out on the tables shows that aluminium alloy 4032-T6 chosen will serve in the fabrication of physical prototype. FEA revealed the nature and level of stresses that will be experienced on the tables, it also revealed region where these stresses will concentrate on them. The analysis also estimated the expected weight of the turning tables 1&2 to be 1.23536 and 0.257182 kg respectively and show that the minimum factor of safety was constantly 15 ul within the tables which means that they will not fail during operation.

[1]  Hang Zhang,et al.  Finite Element Analysis of High-Speed Motorized Spindle Based on ANSYS , 2011 .

[2]  Gary Brown,et al.  A Miniature Open Channel Weir For The Standard Classroom: Implementation And Assessment , 2009 .

[3]  M. J. Jackson,et al.  Finite Element Analysis of Desktop Machine Tools for Micromachining Applications , 2012 .

[4]  Taylan Altan,et al.  Estimation of tool wear in orthogonal cutting using the finite element analysis , 2004 .

[5]  R. Dunlea.  Australian Association for Research in Education (AARE) , 2005 .

[6]  A. Chickering,et al.  Seven Principles for Good Practice in Undergraduate Education , 1987, CORE.

[7]  Suzy Edwards,et al.  Teacher education and problem based learning: exploring the issues and identifying the benefits , 2005 .

[8]  R. Tamblyn,et al.  Problem-based learning : an approach to medical education , 1980 .

[9]  E. Dale.  Audio-visual methods in teaching , 1946 .

[10]  Mahen Mahendran.  Applications of Finite Element Analysis in Structural Engineering , 2007 .

[11]  Ashley Ater Kranov,et al.  Multi-Disciplinary Project-Based Paradigm that Uses Hands-on Desktop Learning Modules and Modern Learning Pedagogies , 2011 .

[12]  Bernard J. Van Wie,et al.  Practical Considerations For Miniaturized Hands On Learning Stations , 2006 .

[13]  Kellah M. Edens.  Preparing Problem Solvers for the 21st Century through Problem-Based Learning , 2000 .

[14]  Mohd Hanim Osman,et al.  Finite element analysis of cold formed steel connections , 2011 .

[15]  Catherine H. Crouch,et al.  Classroom Demonstrations: Learning Tools Or Entertainment? , 2004 .