A New Decoupled CFD and FEM Methodology for the Fatigue Strength Assessment of an Engine Head

[1]  E. Mcassey,et al.  Comparative Performance of Ethylene Glycol/Water and Propylene Glycol/Water Coolants in the Convective and Forced Flow Boiling Regimes , 1995 .

[2]  F. Menter.  ZONAL TWO EQUATION k-w TURBULENCE MODELS FOR AERODYNAMIC FLOWS , 1993 .

[3]  Eric Charkaluk,et al.  An energetic approach in thermomechanical fatigue for silicon molybdenum cast iron , 2000 .

[4]  J. Chaboche.  Time-independent constitutive theories for cyclic plasticity , 1986 .

[5]  I. C. Finlay,et al.  The Application of Precision Cooling to the Cylinder-Head of a Small, Automotive, Petrol Engine , 1988 .

[6]  J. Chaboche.  Constitutive equations for cyclic plasticity and cyclic viscoplasticity , 1989 .

[7]  Comparison of boiling curves between a standard S.I. engine and a flow loop for a mixture of ethylene glycol and water , 2006 .

[8]  Vedat S. Arpaci,et al.  A model for the instantaneous heat transfer and turbulence in a spark ignition engine , 1980 .

[9]  A. Constantinescu,et al.  On a failure criterion for thermomechanical multiaxial low cycle fatigue and its industrial application , 1998 .

[10]  R. P. Skelton,et al.  Energy criterion for high temperature low cycle fatigue failure , 1991 .

[11]  G. R. Herdin,et al.  Analysis of Low Cycle Liner Flange Fatigue in Locomotive Engines , 2002 .

[12]  Masaichi Yoshida,et al.  Variation of Heat Flux through a Combustion Chamber Wall of Pre-chamber type Diesel Engine : Heat Flux through Piston Crown, Cylinder Head, Suction Valve, Exhaust Valve, Pre-combustion Chamber and Exhaust Port Wall , 1982 .

[13]  F. Menter.  Improved two-equation k-omega turbulence models for aerodynamic flows , 1992 .

[14]  C. Feltner,et al.  Microplastic Strain Hysteresis Energy as a Criterion for Fatigue Fracture , 1961 .

[15]  Evangelos G. Giakoumis,et al.  Development of cumulative and availability rate balances in a multi-cylinder turbocharged indirect injection Diesel engine , 1997 .

[16]  Eric Charkaluk,et al.  Thermomechanical design in the automotive industry , 2004 .