Oxidation Behavior of Ferritic Stainless Steels under SOFC Interconnect Exposure Conditions

The oxidation of ferritic stainless steels has been studied under solid oxide fuel cell (SOFC) interconnect “dual” exposure conditions, i.e. simultaneous exposure to air on one side of the sample, and moist hydrogen on the other side. This paper focuses on the oxidation behavior of ferritic stainless steels during the isothermal oxidation in the dual environments. It was found that scales grown on the air side under these dual exposure conditions can be significantly different from scales grown on samples exposed to air on both sides. In contrast, no substantial difference was observed between the scales grown on the fuel side of the dual atmosphere samples and scales grown on samples exposed to moist hydrogen on both sides. AISI430, with 17% Cr, suffered localized attack via formation of Fe2O3 hematite-rich nodules on the air side of dual exposure samples, while the spinel top layer of the air side scale of Crofer22 APU (23% Cr) was enriched in iron. For E-brite, with the highest Cr content (27%), no unusual phases were found in the scale on the air side, but it was noticed the air side scale was less dense and appeared to be more prone to defects than the scalemore » grown in air only. The anomalous oxidation behavior of ferritic stainless steels on the air side of dual exposure specimens is related to the transport of hydrogen through the steel and its subsequent presence in the air side scale.« less

[1]  G. Wood,et al.  International Workshop on High-Temperature Corrosion , 1996 .

[2]  A. Rahmel,et al.  Einfluss von wasserdampf und kohlendioxyd auf die oxydation von eisen in sauerstoff bei hohen temperaturen , 1965 .

[3]  Rune Bredesen,et al.  High temperature corrosion in SOFC environments , 1992 .

[4]  D. Young,et al.  High-temperature corrosion in mixed gas environments , 1995 .

[5]  B. Steele,et al.  Materials for fuel-cell technologies , 2001, Nature.

[6]  T. Atake,et al.  Oxidation behavior of sus430 stainless steel in moist atmospheres at 873 k , 1992 .

[7]  N. Minh.  Ceramic Fuel Cells , 1993 .

[8]  C. T. Fujii,et al.  The Mechanism of the High‐Temperature Oxidation of Iron‐Chromium Alloys in Water Vapor , 1964 .

[9]  D. Stöver,et al.  Oxidation behaviour of ferrous alloys used as interconnecting material in solid oxide fuel cells , 2003 .

[10]  T. Hodgkiess,et al.  A Comparison of the Oxidation of Fe&bCr, NiCr and CoCr alloys in oxygen and water vapour , 1970 .

[11]  R. Janakiraman,et al.  The effect of water vapor on the oxidation of alloys that develop alumina scales for protection , 1999 .

[12]  M. Mori,et al.  Sintering and thermal expansion characterization of Al-doped and Co-doped lanthanum strontium chromites synthesized by the Pechini method , 2002 .

[13]  John B. Goodenough,et al.  Characterization of Iron-Based Alloy Interconnects for Reduced Temperature Solid Oxide Fuel Cells , 2000 .

[14]  T. Norby,et al.  Hydrogen in Chromium: Influence on the High-Temperature Oxidation Kinetics in O2, Oxide-Growth Mechanisms, and Scale Adherence , 1999 .

[15]  Richard J. Chater,et al.  Why stainless steel corrodes , 2002, Nature.

[16]  Y. Larring,et al.  HT Corrosion of a Cr-5 wt % Fe-1 wt % Y 2 O 3 Alloy and Conductivity of the Oxide Scale Effects of Water Vapor , 2003 .

[17]  Masayuki Dokiya,et al.  SOFC system and technology , 2002 .

[18]  Gary D. Maupin,et al.  Phase Transitions and Transient Liquid-Phase Sintering in Calcium-Substituted Lanthanum Chromite , 2005 .

[19]  A. Holt,et al.  Electrical conductivity of Cr2O3 doped with TiO2 , 1999 .

[20]  Z. Yang,et al.  Anomalous Corrosion Behavior of Stainless Steels under SOFC Interconnect Exposure Conditions , 2003 .

[21]  Y. Tsai,et al.  Critical Hydrogen Concentration for the Brittle Fracture of AISI 430 Stainless Steel , 1996 .

[22]  A. Holt,et al.  Electrical conductivity and defect structure of Cr2O3. I. High temperatures (>∼1000°C) , 1994 .

[23]  S. Singhal.  Solid oxide fuel cells for stationary, mobile, and military applications , 2002 .

[24]  T. Brylewski,et al.  Application of Fe–16Cr ferritic alloy to interconnector for a solid oxide fuel cell , 2001 .

[25]  J. Hardy,et al.  Sintering and Properties of Mixed Lanthanide Chromites , 2001 .

[26]  B. Gleeson,et al.  Oxidation of multicomponent two-phase alloys , 1995 .

[27]  R. D. Shannon.  Revised effective ionic radii and systematic studies of interatomic distances in halides and chalcogenides , 1976 .

[28]  K. S. Weil,et al.  Selection and Evaluation of Heat-Resistant Alloys for SOFC Interconnect Applications , 2003 .

[29]  P. Kofstad.  Defects and transport properties of metal oxides , 1995 .