Optimal sensor placement based on multiattribute decision-making considering the common cause failure
暂无分享,去创建一个
[1] Yonghong Liu,et al. Dynamic Bayesian network modeling of reliability of subsea blowout preventer stack in presence of common cause failures , 2015 .
[2] Qazi Muhammad Nouman Amjad,et al. Calculation and updating of Common Cause Failure unavailability by using alpha factor model , 2016 .
[3] Kai Xue,et al. Optimal sensor placement for active control of floor vibration considering spillover effect associated with modal filtering , 2018 .
[4] Akira Yamaguchi,et al. α-Decomposition for estimating parameters in common cause failure modeling based on causal inference , 2013, Reliab. Eng. Syst. Saf..
[5] D. Kammer. Sensor Placement for On-Orbit Modal Identification and Correlation of Large Space Structures , 1990, 1990 American Control Conference.
[6] Yu Liu,et al. Evidential network-based failure analysis for systems suffering common cause failure and model parameter uncertainty , 2018, Proceedings of the Institution of Mechanical Engineers, Part C: Journal of Mechanical Engineering Science.
[7] Syed Imtiaz,et al. Dynamic availability assessment of safety critical systems using a dynamic Bayesian network , 2018, Reliab. Eng. Syst. Saf..
[8] Marko Cepin,et al. A new method for explicit modelling of single failure event within different common cause failure groups , 2012, Reliab. Eng. Syst. Saf..
[9] Sohag Kabir,et al. An overview of fault tree analysis and its application in model based dependability analysis , 2017, Expert Syst. Appl..
[10] Nan Xiao,et al. Reliability block diagram methods for system reliability analysis of spatial structures , 2016 .
[11] T. Assaf,et al. Design for diagnosis using a diagnostic evaluation measure , 2005, IEEE Autotestcon, 2005..
[12] Ka-Veng Yuen,et al. Efficient Bayesian sensor placement algorithm for structural identification: a general approach for multi‐type sensory systems , 2015 .
[13] Michael L. Tinker,et al. Optimal placement of triaxial accelerometers for modal vibration tests , 2002 .
[14] Philippe Weber,et al. System reliability aware Model Predictive Control framework , 2017, Reliab. Eng. Syst. Saf..
[15] Meng Lin,et al. Quantitative analysis of dynamic fault trees using improved Sequential Binary Decision Diagrams , 2015, Reliab. Eng. Syst. Saf..
[16] Chen Yang,et al. An interval effective independence method for optimal sensor placement based on non-probabilistic approach , 2017 .
[17] Daniel C. Kammer. Sensor set expansion for modal vibration testing , 2005 .
[18] Mohamed Sallak,et al. Extended Component Importance Measures Considering Aleatory and Epistemic Uncertainties , 2013, IEEE Transactions on Reliability.
[19] Gwo-Hshiung Tzeng,et al. Compromise solution by MCDM methods: A comparative analysis of VIKOR and TOPSIS , 2004, Eur. J. Oper. Res..
[20] C. Papadimitriou,et al. The effect of prediction error correlation on optimal sensor placement in structural dynamics , 2012 .
[21] Q. Feng,et al. Optimizing well placement in a coalbed methane reservoir using the particle swarm optimization algorithm , 2012 .
[22] Tao Feng,et al. Optimal Sensor Placement Based on System Reliability Criterion Under Epistemic Uncertainty , 2018, IEEE Access.
[23] Heung-Fai Lam,et al. Optimal sensor configuration of a typical transmission tower for the purpose of structural model updating , 2011 .
[24] G. Ghodrati Amiri,et al. Structural damage detection using sparse sensors installation by optimization procedure based on the modal flexibility matrix , 2016 .
[25] Costas Papadimitriou,et al. Optimal sensor placement for multi-setup modal analysis of structures , 2017 .
[26] Masoud Pourali,et al. A Functional Sensor Placement Optimization Method for Power Systems Health Monitoring , 2013 .
[27] Ting-Hua Yi,et al. Multiaxial sensor placement optimization in structural health monitoring using distributed wolf algorithm , 2016 .
[28] Tao Yin,et al. Vibration-based damage detection for structural connections using incomplete modal data by Bayesian approach and model reduction technique , 2017 .
[29] Byeng D. Youn,et al. Development of a stochastic effective independence (SEFI) method for optimal sensor placement under uncertainty , 2018, Mechanical Systems and Signal Processing.
[30] Chen Yang,et al. Optimal sensor placement for deployable antenna module health monitoring in SSPS using genetic algorithm , 2017 .
[31] Xilin Lu,et al. Model‐Reference Health Monitoring of Hysteretic Building Structure Using Acceleration Measurement with Test Validation , 2016, Comput. Aided Civ. Infrastructure Eng..
[32] Bin Ma,et al. Optimal sensor placement for large structures using the nearest neighbour index and a hybrid swarm intelligence algorithm , 2013 .
[33] Mohammad Pourgol-Mohammad,et al. Fault Diagnosis Improvement Using Dynamic Fault Model in Optimal Sensor Placement: A Case Study of Steam Turbine , 2017, Qual. Reliab. Eng. Int..
[34] Živa Bricman Rejc,et al. An extension of Multiple Greek Letter method for common cause failures modelling , 2014 .
[35] Weiwen Peng,et al. Reliability analysis of complex multi-state system with common cause failure based on evidential networks , 2018, Reliab. Eng. Syst. Saf..
[36] Jianchun Xing,et al. A New Optimal Sensor Placement Strategy Based on Modified Modal Assurance Criterion and Improved Adaptive Genetic Algorithm for Structural Health Monitoring , 2015 .
[37] Hu-Chen Liu,et al. A novel approach for failure mode and effects analysis using combination weighting and fuzzy VIKOR method , 2015, Appl. Soft Comput..
[38] Mohammad Pourgol-Mohammad,et al. Sensor placement determination in system health monitoring process based on dual information risk and uncertainty criteria , 2017 .
[39] Miroslaw J. Skibniewski,et al. A dynamic Bayesian network based approach to safety decision support in tunnel construction , 2015, Reliab. Eng. Syst. Saf..
[40] Salvatore J. Bavuso,et al. Dynamic fault-tree models for fault-tolerant computer systems , 1992 .
[41] Nima Khakzad,et al. Dynamic safety assessment of natural gas stations using Bayesian network. , 2017, Journal of hazardous materials.
[42] Sebastiao Simões da Cunha,et al. A multiobjective sensor placement optimization for SHM systems considering Fisher information matrix and mode shape interpolation , 2018, Engineering with Computers.
[43] C. Guedes Soares,et al. Optimal sensor placement and assessment for modal identification , 2018, Ocean Engineering.