Extracting bottom information from towed-array reverberation data. Part II: Extraction procedure and modelling methodology

Abstract Reverberation data were gathered on the NATO Research Vessel Alliance, using the SACLANTCEN/NURC towed arrays, during the Rapid Response Exercises (1996–1998) and the Boundary Characterization experiments (2000–2004). Most of the sites were in the Mediterranean, but there were shallow-water sites on the east and west Atlantic continental shelves. A companion paper discusses the data gathering, polar-plot displays, and at-sea rapid environmental assessment of the reverberation and scattering features. This paper describes our efforts to use reverberation data from beam time series without prominent scattering features to extract estimates of bottom loss and scattering strength. The emphasis of this paper is on the procedure for extraction of the geoacoustic properties of the seafloor and on the modelling methodology used for the model-data comparisons. Towed-array beam patterns are included in the modelling, so polar plots of model-data differences can be used to provide a crude scattering map of the area. A manual inversion procedure was used at sea during the experiments for extracting bottom properties; the results compared reasonably well with post-trial measurements and estimates using an automated version of the extraction procedure. [Work supported in part by the US Office of Naval Research, DRDC Atlantic, and NATO SACLANTCEN/NURC].

[1]  Dale D. Ellis,et al.  A SHALLOW-WATER NORMAL-MODE REVERBERATION MODEL , 1995 .

[2]  Nicholas C. Makris,et al.  Fish Population and Behavior Revealed by Instantaneous Continental Shelf-Scale Imaging , 2006, Science.

[3]  J.R. Preston,et al.  Using Triplet Arrays for Broadband Reverberation Analysis and Inversions , 2007, IEEE Journal of Oceanic Engineering.

[4]  Robert J. Urick,et al.  Principles of underwater sound , 1975 .

[5]  C. Harrison,et al.  Closed-form expressions for ocean reverberation and signal excess with mode stripping and Lambert's law. , 2003, The Journal of the Acoustical Society of America.

[6]  Charles W. Holland,et al.  Coupled scattering and reflection measurements in shallow water , 2002 .

[7]  Dale D. Ellis.  Shallow water reverberation: normal-mode model predictions compared with bistatic towed-array measurements , 1993 .

[8]  D. Ellis,et al.  Bistatic reverberation calculations using a three-dimensional scattering function , 1991 .

[9]  Judith L. Bishop,et al.  Inverting Sea Bed Acoustic Parameters from Reverberation Data , 1995 .

[10]  C. Holland,et al.  Boundary characterization experiment series overview , 2005, IEEE Journal of Oceanic Engineering.

[11]  H. Weinberg,et al.  Generic sonar Model , 1982 .

[12]  Peter Gerstoft,et al.  Full Field Inversion Methods In Ocean And Seismo Acoustics , 1995 .

[13]  Extracting sea‐bottom information from reverberation data , 1999 .

[14]  R. P. Chapman,et al.  Surface Backscattering Strengths Measured with Explosive Sound Sources , 1962 .

[15]  Altan Turgut,et al.  Inversion of bottom/subbottom statistical parameters from acoustic backscatter data , 1997 .

[16]  Dale D. Ellis.  Effective vertical beam patterns for ocean acoustic reverberation calculations , 1991 .

[17]  Dale D. Ellis,et al.  Extracting bottom information from towed-array reverberation data: Part I: Measurement methodology , 2009 .

[18]  R.C. Gauss,et al.  Geoacoustic parameter extraction using reverberation data from the 2000 boundary characterization experiment on the Malta plateau , 2005, IEEE Journal of Oceanic Engineering.