3D study of cooling system effect on the heat transfer during polymer injection molding

The aim of the cooling system of a plastic injection mold is to provide thermal regulation in the injection molding process. When the hot plastic melt enters the mold cavity, it cools down and solidifies by dissipating heat through the cooling system. To study the effect of the cooling system design on the solidification and heat transfer of polymer by injection molding, a full three-dimensional time-dependent injection molding numerical analysis is carried out. The configuration studied consists of the mold with cuboids-shape cavity having two different thicknesses. The cooling of the polymer material is carried out by cooling water flowing through horizontal six cooling channels. A numerical model by finite volume is used for the solution of the physical model. A validation of the numerical model is presented. The effect of the cooling channels position and their cross-section shape on the cooling process is carried out. The results indicate that, for the same cross-sectional area and coolant flow rate of the cooling channels, the cooling channels having the form rectangular perform the minimum time required to completely solidify the plastic product. They also indicate that when the cooling channels approach to the product surface, the cooling efficiency increases.

[1]  V. Voller.  FAST IMPLICIT FINITE-DIFFERENCE METHOD FOR THE ANALYSIS OF PHASE CHANGE PROBLEMS , 1990 .

[2]  S. M. Sapuan,et al.  Design and thermal analysis of plastic injection mould , 2006 .

[3]  Suresh G. Advani,et al.  Gate elements at injection locations in numerical simulations of flow through porous media: applications to mold filling , 2004 .

[4]  D. M. Gao.  A three-dimensional hybrid finite element-volume tracking model for mould filling in casting processes , 1999 .

[5]  H. Qiao.  Transient mold cooling analysis using BEM with the time-dependent fundamental solution , 2005 .

[6]  Omer Eyercioglu,et al.  Development of an expert system for the determination of injection moulding parameters of thermoplastic materials: EX-PIMM , 2002 .

[7]  D. A. Caulk,et al.  SPECIAL BOUNDARY INTEGRAL EQUATIONS FOR APPROXIMATE SOLUTION OF LAPLACE'S EQUATION IN TWO-DIMENSIONAL REGIONS WITH CIRCULAR HOLES , 1981 .

[8]  Wen-Bin Young,et al.  Study on residual stresses of thin-walled injection molding , 2005 .

[9]  Optimum cooling system design of a free-form injection mold using an abductive network , 2002 .

[10]  J. Caltagirone,et al.  A One-Cell Local Multigrid Method for Solving Unsteady Incompressible Multiphase Flows , 2000 .

[11]  Constantin Chassapis,et al.  Optimal cooling system design for multi-cavity injection molding , 1997 .

[12]  C. A. Hieber,et al.  A unified simulation of the filling and postfilling stages in injection molding. Part I: Formulation , 1991 .

[13]  Tae-Won Park,et al.  A new process of gas-assisted injection molding for faster cooling , 2004 .

[14]  H. Qiao.  A systematic computer-aided approach to cooling system optimal design in plastic injection molding , 2006 .

[15]  C. G. Li,et al.  Plastic injection mould cooling system design by the configuration space method , 2008, Comput. Aided Des..

[16]  Philippe Angot,et al.  Contribution à l'étude des transferts thermiques dans des systèmes complexes : application aux composants électroniques , 1989 .

[17]  Dequn Li,et al.  Analysis of thermal residual stress in plastic injection molding , 2000 .