Preview Controller Design for Vehicle Stability With V2V Communication

This paper presents a design method of a preview controller for vehicle stability with vehicle-to-vehicle (V2V) communication. Using V2V communication technology, a driver's steering input of a preceding vehicle is obtained on a following vehicle for preview control. To cope with changes in speed and intervehicle distance in a real situation, a position-based sampling is used. With the position-based sampling data, the time-based preview data are resampled by interpolation. For the controller design, linear vehicle modes describing yaw and roll motions are used. To design a preview controller on the following vehicle with the previewed steering input, a linear optimal preview control methodology is adopted. To validate the preview control with V2V communication in terms of vehicle stability, a simulation is conducted using a vehicle simulation package.

[1]  Chae Wook Lim,et al.  An investigation into the structures of linear quadratic controllers for vehicle rollover prevention , 2013 .

[2]  Arthur E. Bryson,et al.  Applied Optimal Control , 1969 .

[3]  Simos A. Evangelou,et al.  Advances in the development of a virtual car driver , 2009 .

[4]  Rajesh Rajamani,et al.  Vehicle dynamics and control , 2005 .

[5]  R. S. Sharp,et al.  Performance enhancement of limited-bandwidth active automotive suspensions by road preview , 1994 .

[6]  Kyongsu Yi,et al.  Design of an active roll control system for hybrid four-wheel-drive vehicles , 2013 .

[7]  Seongjin Yim,et al.  Unified chassis control with electronic stability control and active front steering for under-steer prevention , 2015 .

[8]  Marcelo H. Ang,et al.  Multi-vehicle motion coordination using V2V communication , 2015, 2015 IEEE Intelligent Vehicles Symposium (IV).

[9]  Youngjin Park,et al.  Design of rollover prevention controller with linear matrix inequality-based trajectory sensitivity minimisation , 2011 .

[10]  Huei Peng,et al.  Connected and Automated Vehicles , 2016 .

[11]  Seongjin Yim,et al.  Design of a Preview Controller for Vehicle Rollover Prevention , 2011, IEEE Transactions on Vehicular Technology.

[12]  Eric Chan,et al.  SARTRE Automated Platooning Vehicles , 2016 .

[13]  Geoff Rideout,et al.  Using lead vehicle response to generate preview functions for active suspension of convoy vehicles , 2010, Proceedings of the 2010 American Control Conference.

[14]  Yoshiaki Irie,et al.  Vehicle behavior control device with means for preventing erroneous control due to a shift of the center of a yaw rate sensor , 1998 .

[15]  Vicente Milanés Montero,et al.  Cooperative Adaptive Cruise Control in Real Traffic Situations , 2014, IEEE Transactions on Intelligent Transportation Systems.

[16]  Huei Peng,et al.  An adaptive lateral preview driver model , 2005 .

[17]  加藤 宏和.  Vehicle control apparatus, the control method , 2013 .

[18]  Takeshi Tsuchiya,et al.  Digital sliding mode servo systems with preview feedforward compensation , 2004 .

[19]  Geoff Rideout,et al.  Using the lead vehicle as preview sensor in convoy vehicle active suspension control , 2012 .

[20]  노현석,et al.  Observer-based preview control of active vehicle suspensions = 관측기를 이용한 차량의 예견 능동 제어 , 1999 .

[21]  Charles C. MacAdam,et al.  Application of an Optimal Preview Control for Simulation of Closed-Loop Automobile Driving , 1981, IEEE Transactions on Systems, Man, and Cybernetics.

[22]  Joshué Pérez,et al.  Making transport safer: V2V-based automated emergency braking system , 2011 .

[23]  Aleksander Hac.  Optimal Linear Preview Control of Active Vehicle Suspension , 1992 .

[24]  Eylem Ekici,et al.  Vehicular Networking: A Survey and Tutorial on Requirements, Architectures, Challenges, Standards and Solutions , 2011, IEEE Communications Surveys & Tutorials.

[25]  Mike Lukuc,et al.  Vehicle-to-Vehicle Communications: Readiness of V2V Technology for Application , 2014 .