Indoor test methods for solar collectors are widely accepted and recommended by ASHRAE. The development of a solar simulator for indoor testing and the certification procedure for photo-thermal solar devices is discussed in this paper. The system consists of 14 quartz halogen lamps and provides a testing area of about 1 x 1 m. The irradiance can be varied from 400 to 1500 W/m2. This is achieved by varying the input power supplied to individual lamps. The radiation output characteristics of a single lamp have been studied. The distribution of intensity over the covered area of 1·20 x 1·20 m has been recorded using a precision Eppley pyranometer. A variety of collectors--evacuated tubular collectors and flat-plate collectors of both liquid and air heating types--has been tested under sufficiently stable insolation conditions. Results for a conventional solar air heater are presented together with suggestions for further improvements.
[1]
D. P. Grimmer,et al.
Small-scale solar simulator for indoor testing of collector modules and materials
,
1979
.
[2]
P. I. Cooper,et al.
Some factors affecting the absorption of solar radiation in solar stills
,
1972
.
[3]
P. Krusi,et al.
Design of an inexpensive solar simulator
,
1979
.
[4]
F. Simon.
Flat-plate solar-collector performance evaluation with a solar simulator as a basis for collector selection and performance prediction
,
1975
.
[5]
E.J.G. Beeson,et al.
The CSI lamp as a source of radiation for solar simulation
,
1978
.
[6]
H. B. Curtis,et al.
Low-cost, air mass 2 solar simulator
,
1974
.
[7]
H. B. Curtis,et al.
Operational performance of a low cost, air mass 2 solar simulator
,
1975
.