Economic modelling and model-based process optimization of membrane distillation

Abstract Membrane distillation (MD) is a thermally driven separation process, operated at moderate temperature, allowing for the use of waste heat as driving force. While the literature is saturated with lab-scale models, almost none exist for designing a complete MD system. Based on previously published and thoroughly validated models, this work demonstrates a graphical user interface tool, capable of designing a complete membrane distillation system, including all of the supporting equipment and able to predict the price of the obtained distillate for the most commonly studied and used membrane distillation configurations. The user can also optimize the module geometry based on specific requirements. Four different case studies are discussed, ranging from 2 to 1000 m3 of distillate per day, with final brine salinity up to 20 wt%, feed temperature up to 80 ° C. The optimal system design for each case is demonstrated. The distillate price varied from 25 €/m3 of distillate for the smallest scale to 2.1 €/m3 for the largest scale. Finally, the reader is presented with a simplified cost model that can be used to quickly estimate the price of the produced distillate at different production scales and concentration factors.

[1]  Jack Gilron,et al.  Silica Fouling in Direct Contact Membrane Distillation , 2013 .

[2]  Guillermo Zaragoza,et al.  Productivity analysis of two spiral-wound membrane distillation prototypes coupled with solar energy. , 2015 .

[3]  Lucio Rizzuti,et al.  CFD simulation of a membrane distillation module channel , 2009 .

[4]  Ingmar Nopens,et al.  Influence of membrane thickness and process conditions on direct contact membrane distillation at different salinities , 2016 .

[5]  Jun-de Li,et al.  Modelling heat and mass transfers in DCMD using compressible membranes , 2012 .

[6]  W. Krantz,et al.  Effect of a macromolecular- or bio-fouling layer on membrane distillation , 2014 .

[7]  Noam Lior,et al.  Transport analysis of air-gap membrane distillation , 2005 .

[8]  E. Drioli,et al.  Potential of membrane distillation in seawater desalination: Thermal efficiency, sensitivity study and cost estimation , 2008 .

[9]  Gideon Oron,et al.  Economic Assessment of an Integrated Membrane System for Secondary Effluent Polishing for Unrestricted Reuse , 2012 .

[10]  Mohamed Khayet,et al.  Monte Carlo simulation and experimental heat and mass transfer in direct contact membrane distillation , 2010 .

[11]  John H. Lienhard,et al.  Superhydrophobic condenser surfaces for air gap membrane distillation , 2015 .

[12]  Ingmar Nopens,et al.  Modelling approaches in membrane distillation: A critical review , 2015 .

[13]  Jianhua Zhang,et al.  Theoretical and experimental investigation of membrane distillation , 2011 .

[14]  Mohamed Khayet,et al.  Modelling mass transport through a porous partition: Effect of pore size distribution , 2004 .

[15]  T. Kohl,et al.  Waste heat problems and solutions in geothermal energy , 2004, Geological Society, London, Special Publications.

[16]  Chris Dotremont,et al.  How to select a membrane distillation configuration? Process conditions and membrane influence unraveled , 2016 .

[17]  Jun-de Li,et al.  Effect of applied pressure on performance of PTFE membrane in DCMD , 2011 .

[18]  Andrea Cipollina,et al.  Modelling flow and heat transfer in spacer-filled membrane distillation channels using open source CFD code , 2013 .

[19]  Enrico Drioli,et al.  Optimization of module length for continuous direct contact membrane distillation process , 2016 .

[20]  Ingmar Nopens,et al.  Calibration and analysis of a direct contact membrane distillation model using Monte Carlo Filtering , 2016 .

[21]  Seockheon Lee,et al.  Dewatering of source-separated human urine for nitrogen recovery by membrane distillation , 2016 .

[22]  N. Vlachakis,et al.  Energy consumption and membrane replacement cost for seawater RO desalination plants , 2003 .

[23]  Mohammad Marufuzzaman,et al.  Truck versus pipeline transportation cost analysis of wastewater sludge , 2015 .

[24]  Ludovic F. Dumée,et al.  Advances in Membrane Distillation for Water Desalination and Purification Applications , 2013 .

[25]  M. Khayet.  Membranes and theoretical modeling of membrane distillation: a review. , 2011, Advances in colloid and interface science.

[26]  Ingmar Nopens,et al.  Full-scale direct contact membrane distillation (DCMD) model including membrane compaction effects , 2017 .

[27]  Anthony G. Fane,et al.  Heat transport and membrane distillation coefficients in direct contact membrane distillation , 2003 .

[28]  Nikolay Voutchkov,et al.  Energy use for membrane seawater desalination – current status and trends , 2017 .

[29]  Marek Gryta,et al.  Fouling in direct contact membrane distillation process , 2008 .

[30]  Ingmar Nopens,et al.  Full-scale validated Air Gap Membrane Distillation (AGMD) model without calibration parameters , 2017 .

[31]  Noam Lior,et al.  Heat and mass transfer resistance analysis of membrane distillation , 2006 .

[32]  Ivaylo Plamenov Hitsov,et al.  Direct contact and air gap membrane distillation: Differences and similarities between lab and pilot scale , 2017 .

[33]  Klaus D. Timmerhaus,et al.  Plant design and economics for chemical engineers , 1958 .

[34]  Mohamed Khayet Souhaimi.  Membrane Distillation: Principles and Applications , 2011 .

[35]  N. Hilal,et al.  Membrane distillation: A comprehensive review , 2012 .

[36]  B. Bruggen,et al.  Wetting Resistance of Commercial Membrane Distillation Membranes in Waste Streams Containing Surfactants and Oil , 2017 .