A Study on Shunt Resistor-based Current Measurements for Fast Switching GaN Devices

Current viewing resistor (CVR) based measurement of a high frequency switching cell is presented. The drain current of the low-side GaN HEMT switch was measured at 100 kHz switching frequency for a maximum load current of 8 A and a dc input of 80 V. To analyze the results, both simulations and experiments were used. The parasitic elements of the PCB layout (i.e. calculated using the Ansys-Q3D Extractor software) were included in the simulation model. This paper explains the consequences of mounting CVRs in the common-source path of transistors compared to a circuit without a CVR. Simulation results are found to be in very good agreement with measurements. Hence, the simulation model can be used to estimate the current waveforms when it is not desirable to resort to intrusive measurement methods.

[1]  S. Ziegler,et al.  Current Sensing Techniques: A Review , 2009, IEEE Sensors Journal.

[2]  M. Kramb,et al.  High bandwidth, highly integrated current sensors for high power density electromobility applications , 2016 .

[3]  J.D. van Wyk,et al.  An overview of integratable current sensor technologies , 2003, 38th IAS Annual Meeting on Conference Record of the Industry Applications Conference, 2003..

[4]  Rolf Slatter.  High accuracy, high bandwidth magnetoresistive current sensors for spacecraft power electronics , 2015, 2015 17th European Conference on Power Electronics and Applications (EPE'15 ECCE-Europe).

[5]  By Bob Mammano.  Current Sensing Solutions for Power Supply Designers , 2000 .

[6]  Taoufik Bensalah,et al.  Investigation of Neel Effect technology for current sensors in next-generation aeronautical applications , 2011, Proceedings of the 2011 14th European Conference on Power Electronics and Applications.

[7]  J. Lenz,et al.  Magnetic sensors and their applications , 2006, IEEE Sensors Journal.

[8]  Nando Kaminski,et al.  Optimisation of Shunt Resistors for Fast Transients , 2016 .