The simplicity of fractal-like flow networks for effective heat and mass transport

A variety of applications using disk-shaped fractal-like flow networks and the status of one and two-dimensional predictive models for these applications are summarized. Applications discussed include single-phase and two-phase heat sinks and heat exchangers, two-phase flow separators, desorbers, and passive micromixers. Advantages of using these fractal-like flow networks versus parallel-flow networks include lower pressure drop, lower maximum wall temperature, inlet plenum symmetry, alternate flow paths, and pressure recovery at the bifurcation. The compact nature of microscale fractal-like branching heat exchangers makes them ideal for modularity. Differences between fractal-like and constructal approaches applied to disk-shaped heat sink designs are highlighted, and the importance of including geometric constraints, including fabrication constraints, in flow network design optimization is discussed. Finally, a simple pencil and paper procedure for designing single-phase heat sinks with fractal-like flow networks based solely on geometric constraints is outlined. Benefit-to-cost ratios resulting from geometric-based designs are compared with those from flow networks determined using multivariable optimization. Results from the two network designs are within 11%.

[1]  A. Dukler,et al.  A model for predicting flow regime transitions in horizontal and near horizontal gas‐liquid flow , 1976 .

[2]  Akimaro Kawahara,et al.  Two-Phase Flow Through Square and Circular Microchannels—Effects of Channel Geometry , 2004 .

[3]  P. Cheng,et al.  Heat transfer and pressure drop in fractal tree-like microchannel nets , 2002 .

[4]  Arun S. Mujumdar,et al.  Effect of bifurcation angle in tree-shaped microchannel networks , 2007 .

[5]  Koetsu Yamazaki,et al.  Constructal Design of Cooling Channel in Heat Transfer System by Utilizing Optimality of Branch Systems in Nature , 2007 .

[6]  Alexandre K. da Silva,et al.  Constructal multi-scale tree-shaped heat exchangers , 2004 .

[7]  J. Liburdy,et al.  Predictions of Flow Boiling in Fractal-Like Branching Microchannels , 2005 .

[8]  Deborah V. Pence,et al.  Fluid Flow Through Microscale Fractal-Like Branching Channel Networks , 2003 .

[9]  S. Kandlikar,et al.  An improved correlation for predicting two-phase flow boiling heat transfer coefficient in horizontal and vertical tubes , 1983 .

[10]  Adrian Bejan,et al.  Dendritic heat convection on a disc , 2003 .

[11]  Robert P. H. Chang,et al.  EELS plasmon studies of silver/carbon core/shell nanocables prepared by simple arc discharge , 2007 .

[12]  W. Denk,et al.  Miniature random-access fiber scanner for in vivo multiphoton imaging , 2007 .

[13]  D. Chisholm,et al.  Void Fraction during Two-Phase Flow: , 1973 .

[15]  James A. Liburdy,et al.  Ammonia Desorption in Microscale Fractal-Like Branching Flow Networks , 2004 .

[16]  Deborah V. Pence,et al.  Thermal Characteristics of Microscale Fractal-Like Branching Channels , 2004 .

[17]  Y. Kwak.  Experimental study of two-phase gas-liquid flow in a microscale fractal-like branching flow network , 2008 .

[18]  John R. Thome,et al.  Characterization of diabatic two-phase flows in microchannels: Flow parameter results for R-134a in a 0.5 mm channel , 2006 .

[19]  D. Chisholm.  A theoretical basis for the Lockhart-Martinelli correlation for two-phase flow , 1967 .

[20]  Masahiro Kawaji,et al.  The effect of channel diameter on adiabatic two-phase flow characteristics in microchannels ☆ , 2004 .

[21]  D. Poulikakos,et al.  Laminar mixing, heat transfer and pressure drop in tree-like microchannel nets and their application for thermal management in polymer electrolyte fuel cells , 2004 .

[22]  D. Pence,et al.  REDUCED PUMPING POWER AND WALL TEMPERATURE IN MICROCHANNEL HEAT SINKS WITH FRACTAL-LIKE BRANCHING CHANNEL NETWORKS , 2003 .

[23]  Y. Kwak.  Particle image velocimetry studies of low Reynolds number flow in branching flow networks , 2003 .

[24]  Mario A. Apreotesi.  Microscale thermal management utilizing vapor extraction from a fractal-like branching heat sink , 2007 .

[25]  Laminate Mixing in Micro-Scale Fractal-Like Merging Channel Networks , 2003 .

[26]  J. Liburdy,et al.  Void Fraction Variations in a Fractal-Like Branching Microchannel Network , 2007 .

[27]  D. Pence,et al.  LAMINATE MIXING IN MICROSCALE FRACTAL-LIKE MERGING CHANNEL NETWORKS , 2004 .

[28]  S. Zivi.  Estimation of Steady-State Steam Void-Fraction by Means of the Principle of Minimum Entropy Production , 1964 .

[29]  J. Liburdy,et al.  Vapor Extraction From Flow Boiling in a Fractal-Like Branching Heat Sink , 2007 .

[30]  I. Mudawar,et al.  Measurement and prediction of pressure drop in two-phase micro-channel heat sinks , 2003 .

[31]  Adrian Bejan,et al.  Constructal tree network for fluid flow between a finite-size volume and one source or sink , 1997 .

[32]  Benoit B. Mandelbrot,et al.  Fractal Geometry of Nature , 1984 .

[33]  Adrian Bejan,et al.  Constructal tree-shaped parallel flow heat exchangers , 2006 .

[34]  Arun S. Mujumdar,et al.  Numerical Analysis of Blockage and Optimization of Heat Transfer Performance of Fractal-like Microchannel Nets , 2006 .

[35]  F. White.  Viscous Fluid Flow , 1974 .

[36]  R. Pease,et al.  High-performance heat sinking for VLSI , 1981, IEEE Electron Device Letters.

[37]  James H. Brown,et al.  A General Model for the Origin of Allometric Scaling Laws in Biology , 1997, Science.

[38]  J. Liburdy,et al.  Experimental studies of adiabatic flow boiling in fractal-like branching microchannels , 2011 .

[39]  Adrian Bejan,et al.  Optimal tree-shaped networks for fluid flow in a disc-shaped body , 2002 .

[40]  J. Liburdy,et al.  Adiabatic Flow Boiling in Fractal-Like Microchannels , 2007 .

[41]  J. Liburdy,et al.  Gas–liquid flows in a microscale fractal-like branching flow network , 2009 .

[42]  Dimos Poulikakos,et al.  Efficiency of optimized bifurcating tree-like and parallel microchannel networks in the cooling of electronics , 2009 .

[43]  Haim H. Bau,et al.  Optimization of conduits' shape in micro heat exchangers , 1998 .