BACKGROUND
While it is well recognized that different biomaterials induce thrombosis at low shear rates, the effect of high shear rates may be quite different. We hypothesize that the amount of thrombus formation on a given material can be greatly influenced by the local shear rate.
METHODS
We tested this hypothesis with two different whole blood perfusion loop assays to quantify biomaterial thrombogenicity as a function of shear stress. One assay uses obstructive posts (pins) of material positioned centrally in a tube perfused at high shear rate of >5000 /s for 24h. A second assay uses a parallel plate chamber to perfuse low (<150 /s), medium (~500 /s), and high shear rates over 96h. We evaluated the thrombogenicity of seven different biomaterials including stainless steel, acrylic, ceramic, Dacron, PTFE, silicone, and PVC.
RESULTS
For the pin assay, thrombus mass was significantly greater for stainless steel than either zirconia ceramic or acrylic (p<0.001). Similarly, the parallel plate chamber at high shear showed that steel and PTFE (p<0.02) occluded the chamber faster than acrylic. In contrast, a low shear parallel plate chamber revealed that stainless steel and PTFE were least thrombogenic, while silicone, Dacron and other plastics such as acrylic were most thrombogenic. Histology revealed that high shear thrombi had a large proportion of platelets not seen in the low shear fibrin-rich thrombi.
CONCLUSION
This differential thrombogenicity based on shear rate conditions may be important in the selection of biomaterials for blood-contacting devices.