Current calibration algorithm for bolometer-type uncooled infrared image sensor using pipeline signal processing

In this paper, we propose a pixel averaging current calibration algorithm for reducing fixed pattern noise due to the deviation of bolometer resistance. To reduce fixed pattern noise (FPN), averaging current calibration algorithm by which output current of each bolometer reference pixel is averaged by the averaging current calibration is suggested. The principle of algorithm is that average dark current of reference pixel array is subtracted by a dark current of each active pixel array. After that, the current difference with information of pixel deviation is converted to voltage signal through signal processing. To control the current difference of pixel deviation, a proper calibration current is required. Through this calibration algorithm, nano-ampere order dark currents with small deviations can be obtained. Sensor signal processing is based on a pipeline technique which results in parallel processing leading to very high operation. The proposed calibration algorithm has been implemented by a chip which is consisted of a bolometer active pixel array, a bolometer reference pixel array, average current generators, line memories, buffer memories, current-to-voltage converters (IVCs), a digital-to-analog converters (DACs), and analog-to-digital converters (ADCs). Proposed bolometerresistor pixel array and readout circuit has been simulated and fabricated by 0.35μm standard CMOS process.

[1]  Michael Siegel,et al.  Progress in Development of the Superconducting Bolometer With Microwave Bias and Readout , 2017, IEEE Transactions on Applied Superconductivity.

[2]  Yun Zhou,et al.  Uncooled Microbolometer Infrared Focal Plane Array Without Substrate Temperature Stabilization , 2014, IEEE Sensors Journal.

[3]  E. Belhaire,et al.  FPN Sources in Bolometric Infrared Detectors , 2009, IEEE Sensors Journal.

[4]  I. Angelov,et al.  The Direct Detection Effect in the Hot-Electron Bolometer Mixer Sensitivity Calibration , 2007, IEEE Transactions on Microwave Theory and Techniques.

[5]  Matteo Perenzoni,et al.  A 160×120-pixel uncooled IR-FPA readout integrated circuit with on-chip non-uniformity compensation , 2010, 2010 Proceedings of ESSCIRC.

[6]  Nagesh R. Basavanhally,et al.  Enabling science and technology , 2009 .

[7]  N. Dyakonova,et al.  Terahertz Imaging Using Strained-Si MODFETs as Sensors , 2012 .

[8]  F. Simoens,et al.  Broadband THz Uncooled Antenna-Coupled Microbolometer Array—Electromagnetic Design, Simulations and Measurements , 2012, IEEE Transactions on Terahertz Science and Technology.

[9]  Roi Mendez-Rial,et al.  A high-speed MWIR uncooled multi-aperture snapshot spectral imager for IR surveillance and monitoring , 2016, 2016 IEEE International Conference on Imaging Systems and Techniques (IST).

[10]  Zhongjian Chen,et al.  A 14-bit differential-ramp single-slope column-level ADC for 640×512 uncooled infrared imager , 2016, 2016 IEEE International Symposium on Circuits and Systems (ISCAS).

[11]  Philipp Hillger,et al.  A fully-integrated terahertz near-field sensor for super-resolution imaging in SiGe BiCMOS , 2016, 2016 41st International Conference on Infrared, Millimeter, and Terahertz waves (IRMMW-THz).

[12]  Yael Nemirovsky,et al.  Modeling of CMOS-SOI-MEMS Thermal Antenna for Monolithic Passive Uncooled THz Imagers , 2016, IEEE Photonics Technology Letters.

[14]  G. G. Stokes.  "J." , 1890, The New Yale Book of Quotations.

[15]  Göran Stemme,et al.  Performance model for uncooled infrared bolometer arrays and performance predictions of bolometers operating at atmospheric pressure , 2008 .

[16]  Cheol-Koo Hahn,et al.  Implementation of current-to-voltage converter with wide dynamic range and its application , 2009, 2009 International SoC Design Conference (ISOCC).