A Buck-Boost Converter; Design, Analysis and Implementation Suggested for Renewable Energy Systems

This work introduces a new non-isolated buck-boost DC-DC converter. Interleaved configuration of the suggested structure increases the voltage conversion ratio. The voltage rate of the suggested converter can be stepped-up and stepped down for lower values of duty-cycle, which causes to decrease in the conduction losses of the system. The voltage conversion ratio of the recommended structure is provided with low maximum voltage throughout the semiconductor elements. Additionally, utilizing only one power switch facilitates converter control. Using a single power MOSFET with small conducting resistance, RDS-ON, increases the overall efficiency of the recommended topology. To verify the performance of the presented converter, technical description, mathematical survey, and comparison investigation with similar structures are provided in the literature. Finally, a laboratory scheme with a 100W load power rate at 50 kHz switching frequency is carried out to demonstrate the effectiveness of the proposed converter.

[1]  K. I. Hwu,et al.  A Novel Buck–Boost Converter Combining KY and Buck Converters , 2012, IEEE Transactions on Power Electronics.

[2]  Ebrahim Babaei,et al.  A New Interleaved Bidirectional Zero Voltage Switching DC/DC Converter with High Conversion Ratio , 2017, J. Circuits Syst. Comput..

[3]  Haiyan Li,et al.  A Constant Frequency ZVS Control System for the Four-Switch Buck–Boost DC–DC Converter With Reduced Inductor Current , 2019, IEEE Transactions on Power Electronics.

[4]  Yan Xing,et al.  Full-Range Soft-Switching-Isolated Buck-Boost Converters With Integrated Interleaved Boost Converter and Phase-Shifted Control , 2016, IEEE Transactions on Power Electronics.

[5]  E. Babaei,et al.  A New Structure of Buck-Boost Z-Source Converter Based on Z-H Converter , 2016 .

[6]  F. Sedaghati,et al.  Analysis and implementation of a boost DC–DC converter with high voltage gain and continuous input current , 2020, IET Power Electronics.

[7]  Hossein Shayeghi,et al.  High step‐up DC–DC converter with coupled inductor suitable for renewable applications , 2019, IET Power Electronics.

[8]  Mohamad Reza Banaei,et al.  A Novel Structure for Single-Switch Nonisolated Transformerless Buck–Boost DC–DC Converter , 2017, IEEE Transactions on Industrial Electronics.

[9]  Tsorng-Juu Liang,et al.  Non-inverting buck–boost converter with interleaved technique for fuel-cell system , 2012 .

[10]  Seyed Hossein Hosseini,et al.  Leakage Current Elimination with Improved Non-Isolated Nine-Level Inverter for Grid-Connected PV Panels , 2016 .

[11]  Mummadi Veerachary,et al.  Analysis, Design, and Control of Switching Capacitor Based Buck–Boost Converter , 2019, IEEE Transactions on Industry Applications.

[12]  Julio C. Rosas-Caro,et al.  Quadratic buck–boost converter with positive output voltage and minimum ripple point design , 2018 .

[13]  Hossein Ardi,et al.  Analysis and implementation of a new single-switch buck-boost dc/dc converter , 2014 .

[14]  H. M. Kojabadi,et al.  A Coupled Inductor Based High Voltage Gain DC-DC Converter Using Interleaved Voltage Multiplier Cells , 2020 .

[15]  N. Taghizadegan Kalantari,et al.  Analysis and Design of a New Single Switch Non-Isolated Buck-Boost dc-dc Converter , 2020 .

[16]  Bin Fu,et al.  Disturbance Rejection Control Method of Double-Switch Buck-Boost Converter Using Combined Control Strategy , 2019, Energies.

[17]  Y. Al-Turki,et al.  A review on maximum power point tracking for photovoltaic systems with and without shading conditions , 2017 .

[18]  Philippe Poure,et al.  Service continuity of PV synchronous Buck/Buck-Boost converter with energy storage , 2017, 2017 IEEE International Conference on Environment and Electrical Engineering and 2017 IEEE Industrial and Commercial Power Systems Europe (EEEIC / I&CPS Europe).

[19]  A. Garrigos,et al.  Electric Vehicle Battery Life Extension Using Ultracapacitors and an FPGA Controlled Interleaved Buck–Boost Converter , 2013, IEEE Transactions on Power Electronics.

[20]  Chih-Lung Shen,et al.  Buck-boost-flyback integrated converter with single switch to achieve high voltage gain for PV or fuel-cell applications , 2016 .

[21]  Tuomas Messo,et al.  Power Electronic Converters: Dynamics and Control in Conventional and Renewable Energy Applications , 2017 .

[22]  Yu Huang,et al.  Low-Voltage Stress Buck-Boost Converter With a High-Voltage Conversion Gain , 2020, IEEE Access.

[23]  Seok-Hyun Lee,et al.  A New Buck–Boost Converter With Low-Voltage Stress and Reduced Conducting Components , 2017, IEEE Transactions on Industrial Electronics.

[24]  Mohamad Reza Banaei,et al.  A High Efficiency Nonisolated Buck–Boost Converter Based on ZETA Converter , 2020, IEEE Transactions on Industrial Electronics.

[25]  Hosein Farzanehfard,et al.  A High-Efficiency Interleaved Ultra-High Step-Down DC–DC Converter With Very Low Output Current Ripple , 2019, IEEE Transactions on Industrial Electronics.