Thermal diffusivity of polyolefins by temperature wave analysis

The thermal diffusivities of 25 kinds of polyolefin films, including high-density polyethylene, low-density polyethylene, linear low-density polyethylene, polypropylene, 4-methylpentene, and ethylene–octene copolymer, were determined by temperature wave analysis in a continuous temperature scan. The thermal diffusivity decreased with increasing temperature, and the temperature dependence was steeper in the solid state than in the melt state. A supercooling phenomenon was observed in the crystallization process during cooling. The thermal diffusivity of polyethylene in the solid state was in a good correlation with the density at room temperature, and a higher temperature coefficient was observed in high-density polyethylene with a higher thermal diffusivity. The influence of the catalyst system on the thermal diffusivity was also observed in the ethylene–octene copolymer. The thermal diffusivity was sensitive to the precise change in the microstructure of the crystalline polyolefin, which was influenced not only by the chemical structure but also by the thermal history. © 2005 Wiley Periodicals, Inc. J Appl Polym Sci 99: 1104–1110, 2006

[1]  Xing Zhang,et al.  Measurements of the thermal conductivity and thermal diffusivity of polymers , 2003 .

[2]  J. Seppälä,et al.  Differential scanning calorimetry, small‐angle X‐ray scattering, and wide‐angle X‐ray scattering on homogeneous and heterogeneous ethylene‐α‐copolymers , 2001 .

[3]  H. Reynaers,et al.  Thermal behaviour and morphology of homogeneous ethylene–1-octene copolymers with high comonomer contents , 2000 .

[4]  J. Morikawa,et al.  Thermal Diffusivity Measurement of Polyamide Mesh by Temperature Wave Analysis1 , 2000 .

[5]  J. A. H. Jornada,et al.  Influence of the comonomer content on the thermal and dynamic mechanical properties of metallocene ethylene/1-octene copolymers , 1999 .

[6]  R. Androsch.  Melting and crystallization of poly(ethylene-co-octene) measured by modulated d.s.c. and temperature-resolved X-ray diffraction , 1999 .

[7]  P. J. Phillips,et al.  Nonisothermal melting and crystallization studies of homogeneous ethylene/α‐olefin random copolymers , 1998 .

[8]  J. Morikawa,et al.  Frequency dependent thermal diffusivity of polymers by temperature wave analysis , 1997 .

[9]  A. Hiltner,et al.  Elastomeric blends of homogeneous ethylene-octene copolymers , 1997 .

[10]  J. Morikawa,et al.  Measurement of the thermal diffusivity of thin films by an AC joule-heating method , 1997 .

[11]  K. Nitta,et al.  Compatibility of binary blends of polypropylene with ethylene‐α‐olefin copolymer , 1996 .

[12]  L. Miranda,et al.  Photoacoustic investigation of iodine‐doped polystyrene , 1989 .

[13]  C. L. Choy,et al.  Thermal diffusivity of polymer films by the flash radiometry method , 1987 .

[14]  L. Miranda,et al.  Photoacoustic measurement of thermal diffusivity of polymer foils , 1987 .

[15]  M. Kamal,et al.  The thermal conductivity and diffusivity of polyethylene solids and melts , 1983 .

[16]  C. L. Choy,et al.  Thermal conductivity of oriented crystalline polymers , 1980 .

[17]  C. Choy,et al.  Thermal conductivity of highly oriented polyethylene , 1978 .

[18]  C. Choy,et al.  Thermal diffusivity of polymers by the flash method , 1977 .

[19]  B. Löfgren,et al.  Thermal properties of ethylene/long chain α-olefin copolymers produced by metallocenes , 2002 .

[20]  J. Morikawa,et al.  Study of change in thermal diffusivity of amorphous polymers during glass transition , 1995 .

[21]  L. Miranda,et al.  Photoacoustic monitoring of adhesive curing , 1988 .

[22]  M. J. Adams,et al.  Thermal diffusivity and thickness measurements for solid samples utilising the optoacoustic effect , 1977 .