Fast response measurements of the dispersion of nanoparticles in a vehicle wake and a street canyon

Abstract The distributions of nanoparticles (below 300 nm in diameter) change rapidly after emission from the tail pipe of a moving vehicle due to the influence of transformation processes. Information on this time scale is important for modelling of nanoparticle dispersion but is unknown because the sampling frequencies of available instruments are unable to capture these rapid processes. In this study, a fast response differential mobility spectrometer (Cambustion Instruments DMS500), originally designed to measure particle number distributions (PNDs) and concentrations in engine exhaust emissions, was deployed to measure particles in the 5–1000 nm size range at a sampling frequency of 10 Hz. This article presents results of two separate studies; one, measurements along the roadside in a Cambridge (UK) street canyon and, two, measurements at a fixed position (20 cm above road level), centrally, in the wake of a single moving diesel-engined car. The aims of the first measurements were to test the suitability and recommend optimum operating conditions of the DMS500 for ambient measurements. The aim of the second study was to investigate the time scale over which competing influences of dilution and transformation processes (nucleation, condensation and coagulation) affect the PNDs in the wake of a moving car. Results suggested that the effect of transformation processes was nearly complete within about 1 s after emission due to rapid dilution in the vehicle wake. Furthermore, roadside measurements in a street canyon showed that the time for traffic emissions to reach the roadside in calm wind conditions was about 45 ± 6 s. These observations suggest the hypothesis that the effects of transformation processes are generally complete by the time particles are observed at roadside and the total particle numbers can then be assumed as conserved. A corollary of this hypothesis is that complex transformation processes can be ignored when modelling the behaviour of nanoparticles in street canyons once the very near-exhaust processes are complete.

[1]  D. Brugge,et al.  Near-highway pollutants in motor vehicle exhaust: A review of epidemiologic evidence of cardiac and pulmonary health risks , 2007, Environmental health : a global access science source.

[2]  L. Pirjola,et al.  How significantly does coagulational scavenging limit atmospheric particle production , 2001 .

[3]  Yifang Zhu,et al.  Evolution of particle number distribution near roadways. Part II: the 'Road-to-Ambient' process , 2004 .

[4]  Rex Britter,et al.  Comparative study of measured and modelled number concentrations of nanoparticles in an urban street canyon , 2009 .

[5]  R. Britter,et al.  Effect of wind direction and speed on the dispersion of nucleation and accumulation mode particles in an urban street canyon. , 2008, The Science of the total environment.

[6]  H. Horvath.  Estimation of the average visibility in central Europe , 1995 .

[7]  D. Kittelson.  Engines and nanoparticles: a review , 1998 .

[8]  S. Friedlander.  Smoke, Dust, and Haze: Fundamentals of Aerosol Dynamics , 2000 .

[9]  Corinne Le Quéré,et al.  Climate Change 2013: The Physical Science Basis , 2013 .

[10]  Rex Britter,et al.  Measurements of particles in the 5-1000 nm range close to road level in an urban street canyon. , 2008, The Science of the total environment.

[11]  Hiroaki Minoura,et al.  Roadside nanoparticles corresponding to vehicle emissions during one signal cycle , 2009 .

[12]  P. Mcmurry,et al.  Relationship between particle mass and mobility for diesel exhaust particles. , 2003, Environmental science & technology.

[13]  D. Dockery,et al.  Health Effects of Fine Particulate Air Pollution: Lines that Connect , 2006, Journal of the Air & Waste Management Association.

[14]  J. Fackrell,et al.  Parameters characterising dispersion in the near wake of buildings , 1984 .

[15]  Rex Britter,et al.  Pseudo-simultaneous measurements for the vertical variation of coarse, fine and ultrafine particles in an urban street canyon , 2008 .

[16]  Hanna Vehkamäki,et al.  Formation and growth rates of ultrafine atmospheric particles: a review of observations , 2004 .

[17]  W. MacNee,et al.  Combustion-derived nanoparticles: A review of their toxicology following inhalation exposure , 2005, Particle and Fibre Toxicology.

[18]  Efisio Solazzo,et al.  Evaluation of traffic-producing turbulence schemes within Operational Street Pollution Models using roadside measurements , 2007 .

[19]  F. T. Depaul,et al.  A tracer study of dispersion in an urban street canyon , 1985 .

[20]  Debbie A. Niemeier,et al.  Evolution of particle number distribution near roadways. Part III: Traffic analysis and on-road size resolved particulate emission factors , 2005 .

[21]  Rex Britter,et al.  Treatment of losses of ultrafine aerosol particles in long sampling tubes during ambient measurements , 2008 .

[22]  F. T. Depaul,et al.  Measurements of wind velocities in a street canyon , 1986 .

[23]  Rex Britter,et al.  Street Versus Rooftop Level Concentrations of Fine Particles in a Cambridge Street Canyon , 2009 .