Mining-induced stress change and consequences of stress path on excavation stability — a case study

Abstract For stability assessments as well as for support design, it is important to understand the factors leading to detrimental stress changes. Stress changes not only influence the demand on the rock support, they also change the support capacity of frictional support components such as plain cablebolts. Stress and stress changes are commonly predicted by numerical models but it is rarely possible to verify these predictions. This study presents a practical example illustrating the usefulness of stress change measurements in providing an accurate picture of the mining-induced stress changes and their value for numerical model calibration. Stress changes, associated with mining of the 565#6 stope at Winston Lake Mine, were measured by four CSIRO HI stress cells, two in the hangingwall and two in the back of a sill drift. In order to obtain the full stress history of the hangingwall, stresses at the installation time were calculated by use of a three-dimensional boundary element program — MAP3D. Two types of rockmass failure were observed at this mine: hangingwall delamination and collapse leading to ore dilution, and wedge-like failures in the backs of sill drifts. All stress cells were located such that they were affected by these failure mechanisms. Using measured and predicted stress paths, this study explains the nature of these two failure modes, as experienced at Winston Lake Mine. Excellent correspondence between measured and predicted stresses is achieved for both the hangingwall and the back of the sill drifts. Modelled stress rotations in the hangingwall follow closely the stress rotations determined in the field, except at the end of the monitoring campaign when the stress cells were affected by inelastic straining of the host rock. These measurements assist in understanding the failure processes and in defining the limitations of the adopted numerical models.